JVC RX-7012RSL manual Receiving Radio Broadcasts, Tuning in Stations Manually, Using Preset Tuning

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning in Stations Manually

On the front panel:

1. Press FM/AM to select the band

Using Preset Tuning

Once a station is assigned to a channel number, the station can be quickly tuned. You can preset up to 30 FM and 15 AM (MW/LW)

(FM or AM — MW/LW).

FM/AM

stations.

The last received station of the selected band is tuned in.

•Each time you press the button, the band alternates between FM and AM (MW/LW).

SPK 1

ANALOG L R TUNED VOLUME

To store the preset stations

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel ONLY:

2.Press FM/AM TUNING 5/ °until you find the frequency you want.

•Pressing FM/AM TUNING 5increases the frequency.

•Pressing FM/AM TUNING °decreases the frequency.

From the remote control:

1.Press FM/AM to select the band.

•Each time you press the button, the band alternates between FM and AM (MW/LW).

FM/AM TUNING

FM/AM

1.Tune in the station you want to preset (see “Tuning in Stations Manually”).

•If you want to store the FM reception mode for this station, select the FM reception mode you want. See “Selecting the FM Reception Mode” on page 19.

	SPK 1
ANALOG	L	R	TUNED	VOLUME

2. Press MEMORY.		MEMORY
SPK 1
ANALOG L R	TUNED	VOLUME

2. Press TUNING +/– until you find		+
the frequency you want.
	TUNING
• Pressing TUNING + increases the		−
frequency.

•Pressing TUNING – decreases the frequency.

Notes:

•When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.

•When an FM stereo program is received, the STEREO indicator also lights up.

CH-

“CH-” appears and the channel number position starts flashing on the display for about 5 seconds.

3. Press FM/AM PRESET 5/ °to		FM/AM PRESET
select a channel number while the
channel number position is flashing.
SPK 1
ANALOG L R	TUNED	VOLUME
CH-

Note:

You can use the 10 keys on the remote control to select the preset number. When using the 10 keys, be sure that they are activated for the tuner, not for the CD and others. (See page 32.)

4. Press MEMORY again while the	MEMORY
selected channel number is flashing on
the display.

The selected channel number stops flashing.

The station is assigned to the selected channel number.

SPK 1

ANALOG L R TUNED VOLUME

CH-

5.Repeat steps 1 to 4 until you store all the stations you want.

To erase a stored preset station

Storing a new station on a used number erases the previously stored one.

18