To change the transmittable signals for operating another manufacturer’s DVD player
1.Press and hold AUDIO 
.
2.Press DVD.
3.Enter manufacturer’s code using buttons
and 0.
See the list to the right to find the code.
4. Release AUDIO 
.
After pressing DVD or DVD MULTI, you can perform the following operations on a DVD player:
PLAY3: | Starts playing. |
4: | Returns to the beginning of the current (or |
¢: | previous) tracks. |
Skips to the beginning of the next track. | |
STOP7: | Stops playing. |
PAUSE8: | Stops playing temporarily. To release it, press |
| PLAY3. |
Manufacturer | Codes |
JVC | 00, 02 |
DENON | 01 |
PANASONIC | 03 |
PHILIPS | 13 |
PIONEER | 04, 05, 06 |
RCA | 07 |
SAMSUNG | 08 |
SONY | 09 |
TOSHIBA | 10 |
YAMAHA | 11, 12 |
Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.
After pressing DVD or DVD MULTI, these buttons can be used for the DVD menu operations.
Note:
For detailed menu operations, refer to the
instructions supplied with the discs or the
DVD player.
– CENTER+
| 2 | 3 |
|
| MENU |
TEST | – REAR• L+ | |
4 | 5 | 6 |
|
| ENTER |
– REAR• R+
8 
9
Note:
Refer to the manual supplied with your DVD player.
5.Try to operate your DVD player by pressing one of the above buttons.
•DO NOT forget to turn on the DVD player before pressing one of the above buttons.
If there are more than one code listed for your brand of DVD
player, try each one until the correct one is entered.
38
