JVC RX-7012RSL, RX-7010RBK manual Adjusting the DAP Modes

Adjusting the DAP Modes

Once you have adjusted the DAP modes, the adjustment is memorized for each DAP mode.

Before you start, remember...

• Make sure that you have set the speaker information correctly

(see page 14).

• There is a time limit in doing the following steps. If the setting is

canceled before you finish, start from step 1 again.

From the remote control:

1. Press DSP MODE repeatedly until	DSP
the DAP mode — LIVE CLUB,	MODE
DANCE CLUB, HALL, or
PAVILION — appears on the
display.

The DSP indicator also lights up on the display.

• You cannot adjust the rear speaker output level when you have set

“REAR SPK” to “NO.” See page 14.

On the front panel:

1. Press DSP MODE repeatedly until DSP MODE the DAP mode — LIVE CLUB, DANCE CLUB, HALL, or

PAVILION — appears on the display.

The DSP indicator also lights up on the display.

2. Adjust the rear speaker output levels.

2. Press SOUND.

The 10 keys are activated for sound adjustments.

3. Adjust the rear speaker output

levels.

• To adjust the left rear speaker level, press

REAR•L +/– (from +10 dB to –10 dB).

• To adjust the right rear speaker level, press

REAR•R +/– (from +10 dB to –10 dB).

SOUND

– REAR• L+

5 6

ENTER

– REAR• R+

8 9

1) Press ADJUST repeatedly until one of

the following indications appears on

the display.

“REAR L LEVEL”:

To adjust the left rear speaker level.

“REAR R LEVEL”:

ADJUST SETTING

4. Press EFFECT to select an effect

level you want.

• Each time you press the button, the effect

level changes as follows:

EFFECT

1

	To adjust the right rear speaker level.
2)	Press CONTROL UP 5/DOWN °to
	adjust the selected speaker output level
	(from +10 dB to –10 dB).
3)	Repeat 1) and 2) to adjust the other
	speaker output level.

CONTROL

DOWN UP

DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3

DSP EFFECT 5 DSP EFFECT 4

As the number increases, the selected DAP mode becomes stronger (normally set it to “DSP EFFECT 3”).

3.Adjust the effect level.

1)Press ADJUST repeatedly until “DSP EFFECT” appears on the display. The display changes to show the current setting.

2)Press CONTROL UP 5/DOWN °to select the effect level.

•Each time you press the button, the effect level changes as follows:

ADJUST SETTING

CONTROL

DOWN UP

DSP EFFECT 1DSP EFFECT 2 DSP EFFECT 3

DSP EFFECT 5 DSP EFFECT 4

As the number increases, the selected DAP mode becomes stronger (normally set it to “DSP EFFECT 3”).

28