JVC RV-NB1 manual Troubleshooting, Specifications

Page 23

Troubleshooting

If you are having a problem with your system, check this list for a possible solution before calling for service.

If you cannot solve the problem from the hints given here, or the system has been physically damaged, call a qualified person, such as your dealer, for service.

Symptom

Power does not come on.

No sound is heard.

Poor FM reception.

The track skips.

The disc does not play (“NO PLAY” or “NO DISC” appears).

Specific files on an MP3 disc are not played.

Unable to record.

Unable to operate the remote control.

Operations are disabled.

The cassette holder cannot be opened.

Indicators and the display do not light up while in standby mode.

Possible cause

The power cord is not connected to an AC outlet.

Connections are incorrect, or loose.

Headphones are connected.

MP3 disc is recorded with “packet writing.”

The FM telescopic antenna is not properly extended and positioned.

The disc is dirty or scratched.

The disc is upside down.

The disc is dirty or scratched.

Files other than MP3 are included in the disc.

Cassette record protect tabs are removed.

The path between the remote control and the sensor on the system is blocked.

The batteries have lost their charge.

The built-in microprocessor has malfunctioned due to external electrical interference.

During tape play, the power cord has been unplugged.

Batteries or DC power is used to supply the power.

Action

Insert the plug into the socket.

Check all connections and make corrections. (See page 5.)

Disconnect the headphones.

It cannot be played. Replace the disc.

Fully extend the FM telescopic antenna and turn it for the best reception.

Clean or replace the disc.

Put the disc in with the label side up.

Change the disc.

They cannot be played.

Cover the holes on the back edge of the cassette with tape.

Remove the obstruction.

Replace the batteries.

Unplug the system then plug it back in after a few minutes.

Plug in the power cord and press the ON/STANDBY button.

Specifications

Amplifier

Output Power

 

 

W + 10 W) at 4 (full range),

(Max.)

20

W (10

 

40

W (20

W + 20 W) at 4 , 60 Hz (woofer)

(10% THD)

10

W (5 W + 5 W) at 4 (full range),

 

30

W (15

W + 15 W) at 4 , 60 Hz (woofer)

Input Sensitivity/Impedance (1 kHz)

AUX IN

300 mV/47 k

MIC/GUITAR INPUT: Switchable

MIC

200 – 2 k(6.3 mm dia. plug)

GUITAR

100 k– 1 M(6.3 mm dia. plug)

Output Sensitivity/Impedance (1 kHz)

Phones

16

– 1 k

 

0 – 12 mW/ch output into 32

Cassette Deck

Frequency Response

Type II (High position) 60 Hz – 14 kHz

Wow and Flutter 0.15% (WRMS)

Disc Player

Dynamic range

90 dB

Signal-to-noise ratio 95 dB

Wow and Flutter

Unmeasurable

Tuner

FM Tuner

 

 

Tuning Range

87.50 MHz – 108.00 MHz

AM Tuner

 

 

Tuning Range

(MW) 522

– 1 629 kHz

 

(LW) 144

– 288 kHz

Antenna

FM telescopic antenna

 

Ferrite core antenna for AM (MW/LW)

Speakers

Full range

8 cm 2, 4

Super woofer

16 cm 2, 4

General

Dimensions

690 mm 239 mm 296 mm (W/H/D)

Mass

9.5 kg (without batteries)

 

10.6 kg (with batteries)

Power Specifications

Power Requirements AC 230 V , 50 Hz

DC15V (“R20/D (13F)” batteries (10)) External DC12V (car battery via optional car adapter)

Power Consumption 43 W (power on mode) 1.6 W (in standby mode)

Design and specifications are subject to change without notice.

20

Image 23
Contents RV-NB1 Important for Laser Products Above ALL Table of contents Display window Index of parts and controlsCompu Play One Touch Operation Remote controlCarrying the system AccessoriesUsing the remote control RM-SRVNB1A Getting startedConnecting the AC power cord Connecting the auxiliary equipmentConnecting the microphone/guitar Connecting to the car battery Memory backup batteriesOperating the system on batteries To remove the batteries, remove battery 3 firstBasic operations Turning the power on and offAdjusting the volume Activating clear sound Adjusting the super woofer volumeSelecting the sound mode Sound mode selectionPress Tuner Band Tuning in to a stationSelect a station using one of the following methods Listening to radioTo change the preset stations, repeat the same steps as Presetting stationsSetting a disc Using the remote control onlyUsing the disc player-Normal Play Repeating tracks Programming the playing order of the tracksRandom play Regular play Reverse modePress Reverse Mode Playing back tapesThings to know before you start recording RecordingStandard recording One Track Recording Disc direct recordingMicrophone/guitar mixing Using the microphone/guitarListening to an auxiliary equipment Listening to external equipmentSetting the clock Using the timerSetting the sleep timer Setting the daily timer Care and maintenance Specifications TroubleshootingRV-NB1 Powered Woofer CD System