Integra Connecting the DPC-6.1 to a TV, Selecting the audio outputs, Connecting a power cable

Connecting the DPC-6.1 to a TV

Here is how to connect your DVD Changer to your TV set. In this case, both the video and audio signals will be played back by your TV set.

Connecting the DPC-6.1 to a TV

1.Switch off the DVD Changer and the TV set.

2.Connect the DPC-6.1 to your TV set as shown in the illustration.

VIDEO OUTPUT

					AC INLET
	Y	PBPR	S VIDEO	VIDEO	Do not plug in the
		COMPONENT
					power cable until
					all connections
	OUTPUT	OUTPUT			have been made.
	ANALOG	DIGITAL
	L	COAXIAL	OPTICAL
	R
To ANALOG					Power cable
AUDIO OUT
					(included)
(white)	(red)	(yellow)		To S VIDEO OUT	To wall
					outlet
	To VIDEO OUT				(See below)
					Audio/video connection cable
					(supplied)
					To audio inputs

Signal flow

To video input

(yellow) (white) (red)

Improper connection

S video cable (supplied)

To S video input

If the TV has an S video input, connect the DVD

Changer with the supplied S video cable.

Insert completely

TV or monitor with audio and video inputs

■Selecting the audio outputs

Your DPC-6.1 provides several options for audio playback: you can use the analog or one of the digital audio outputs. If the audio is to be played back by your TV set, connect the ANALOG OUTPUTs to the audio inputs of your TV set and activate them (“Analog 2ch”). See “Audio Settings” on page 36 for details.

Notes:

•See also the instruction manual of the connected TV on how to select the signals transmitted by the DVD Changer.

•Before connecting the DVD Changer to your TV, be sure to turn off the power to and unplug both units from the wall outlet.

•If your TV set has one audio input (monaural), connect a Y cable adapter to the DPC-6.1’s ANALOG OUTPUTs, and the other end of the adapter to the TV’s audio input.

•Be sure to establish a direct video connection between the DPC-6.1 and your TV set. Do not route the video signal through your VCR or other video component. Otherwise the picture may be distorted due to the DVD video’s copy protection.

Connecting a power cable

		VIDEO OUTPUT
				AC INLET
Y	P	P	S VIDEO	VIDEO
	COMPONENT			1
ANALOG		DIGITAL
OUTPUT		OUTPUT
		COAXIAL	OPTICAL
L
R
				2

1.Connect the outlet plug on the included power cable to the AC INLET on the DPC-6.1.

2.Plug-in the other end of the cable to a wall AC outlet.

Notes:

•Do not use any power cable other than the included cable. The included cable is designed for use only with the DPC-6.1. Do not use it for any other device.

•Do not connect or disconnect the outlet plug from the DPC- 6.1 while the other end is plugged into the wall AC outlet.

10