Clarion DXZ825 owner manual Basic Operations

7. OPERATIONS

English

CAUTION

Be sure to lower the volume before switch- ing off the unit power or the ignition key. The unit remembers its last volume setting. If you switch the power off with the volume up, when you switch the power back on, the sud- den loud volume may hurt your hearing and damage the unit.

Adjusting the volume

1.Press the front part of the knob to adjust. The knob will pop up.

2.Turning the [ROTARY] knob clockwise in- creases the volume; turning it counterclock- wise decreases the volume.

∗The volume level is from 0 (minimum) to 33 (maximum).

Turning on/off the power

Note:

•Be careful about using this unit for a long time with- out running the engine. If you drain the car’s battery too far, you may not be able to start the engine and this can reduce the service life of the battery.

1.Press the [FNC] button.

2.The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode.

3.Press and hold the [FNC] button for 1 second or longer to turn off the power for the unit.

Note:

•System check

The first time this unit is turned on after the wire connections are completed, it must check what equipment is connected. When the power is turned on, “SYSTEM CHCK” and “Push POWER” appear in the display alternately, so press the [FNC] button. The system check starts within the unit. When the system check is complete, the power is turned off, so press the [FNC] button again.

Selecting a mode

1.Press the [FNC] button to change the opera- tion mode.

2.Each time you press the [FNC] button, the op- eration mode changes in the following order:

Radio mode ➜ DAB mode ➜ SIRIUS mode ➜ CD mode ➜ DVD deck mode ➜ CD changer mode ➜ MD changer mode ➜ DVD changer mode ➜ TV mode ➜ AUX mode ➜ Radio mode...

∗External equipment not connected with CeNET is not displayed.

∗A Digital Radio (DAB) program can be re- ceived only in Canada.

∗The SIRIUS mode can be also switched using the [SAT] button.

Switching the display

Press the [D] button to select the desired display.

Each time you press the [D] button, the display switches in the following order:

Main display

Clock display

Main display

∗Once selected, the preferred display becomes the display default. When a function adjust- ment such as volume is made, the screen will momentarily switch to that function’s display, then revert back to the preferred display sev- eral seconds after the adjustment.

∗When you have entered a title in a CD/MD, it appears in the main display. If you have not entered a title, “D NO-TITLE” or “T NO- TITLE” appears in the title display instead. For information on how to enter a title, refer to the subsection “Entering titles” in section “Op- erations Common to Each Mode ”.