Clarion DXZ825 owner manual Case of Difficulty, Problem Cause Measure, Dsp

Problem

Cause

Measure

Power does not turn

Fuse is blown.

Replace with a fuse of the same amperage. If

on.

the fuse blows again, consult your store of pur-

(No sound is pro-

chase.

duced.)

Incorrect wiring.

Consult your store of purchase.

No sound output

Power antenna lead is shor-

1. Turn the unit off.

when operating the

ted to ground or excessive

2. Remove all wires attached to the power anten-

unit with amplifiers or

current is required for

na lead. Check each wire for a possible short

power antenna

remote-on the amplifiers or

to ground using an ohm meter.

attached.

power antenna.

3. Turn the unit back on.

4. Reconnect each amplifier remote wire to the

power antenna lead one by one. If the amplifi-

ers turn off before all wires are attached, use

General

Nothing happens

The microprocessor has

an external relay to provide remote-on voltage

Turn off the power, then

Reset button

(excessive current required).

when buttons are

malfunctioned due to noise,

press the [RELEASE]

pressed.

etc.

button and remove the

DCP.

Display is not accu-

Press the reset button

rate.

with a thin rod.

DCP or main unit connec-

Wipe the dirt off with a soft cloth moistened with

tors are dirty.

cleaning alcohol.

Compact disc cannot

Another compact disc is

Eject the compact disc before loading the new

be loaded.

already loaded.

one.

Sound skips or is noi-

Compact disc is dirty.

Clean the compact disc with a soft cloth.

sy.

Compact disc is heavily

Replace with a compact disc with no scratches.

scratched or warped.

CD

Sound is bad directly

Water droplets may form on

Let dry for about 1 hour with the power on.

after power is turned

the internal lens when the

on.

car is parked in a humid

place.

DSP

Poor sound quality

The equalizer levels are too

If the equalizer levels are too high, the sound

high.

may distort. Lower the equalizer levels.