Stopping the Alarm
The alarm is programmed to continuously sound for 60 minutes. To stop the alarm, follow the directions below.
1.SNOOZE / DIMMER Button – Press this button to stop the alarm temporarily. The alarm will stop and automatically resume after 9 minutes.
2.
POWER/STANDBY Button – Press this Button to stop the alarm which will sound again 24 hours later.
3.ALM.1 / MEM- or ALM.2 / MEM+ Button – Press this Button once to stop the alarm and the alarm will sound again 24 hours later.
DIMMER Operation (With AC Adaptor plugged in)
In power off mode, press the SNOOZE / DIMMER Button repeatedly to adjust the LCD backlight to low, middle or high as desired.
Note:
i.With the AC Adaptor plugged in and with power off, press any button except SNOOZE/DIMMER and the LCD backlight will automatically set to high and resume to the preset brightness in approximately 5 seconds.
ii.If using battery power, the LCD backlit is always set to the dimmest level in order to conserve battery power. Press any button the LCD backlight will automatically set to high and resume to the dimmest level in approximately 5 seconds.
Turning the Lamp On/Off
1.You can press the LIGHT button to turn the Lamp on and off.
2.The Lamp will also light automatically one minute before the alarm time is reached and increase to the full brightest level when the alarm time is reached.
3.When you stop the alarm by pressing the SNOOZE/DIMMER, 
POWER, ALM.1/MEM- or ALM.2/MEM+ Button, the Lamp will be turned off at the same time. You can also press the LIGHT Button to turn off the Lamp directly.
4.If the Lamp is on before waking to alarm, radio or iPod, when you stop the alarm by pressing the SNOOZE/DIMMER, 
POWER/STANDBY, ALM.1/MEM- or ALM.2/MEM+ Buttons, the Lamp will remain on. To turn the Lamp off press the LIGHT Button once.
SLEEP OPERATION
Your
10