Jensen JiMS-182 owner manual Setting the Current Time, Activating the Backup Function

Page 5

batteries at the same time as soon as possible to avoid battery leakage.

B. AC Adaptor Operation

1.Insert one end of the AC adaptor into the DC Jack on back of JiMS-182.

2.Connect the AC plug of the AC adaptor to an AC 120V~ 60Hz power source.

Note: The batteries will be automatically disconnected when the AC adaptor is plugged into the DC Jack and the System will operate on AC power.

Note: Unplug the AC adaptor and disconnect the DC Jack when the JiMS-182 is not in use for a long period of time.

C. ACTIVATING THE BACKUP FUNCTION

To activate the backup function of the system remove the Battery Insulation Tag from the backup battery compartment.

Replacing the Lithium Battery

1.Remove the battery tray located on the back of the unit.

2.Replace the exhausted “CR2025” 3V lithium battery with a new one with the “+” side facing upward.

3.Slide the battery tray back into the unit.

IMPORTANT: Be sure that the battery is installed correctly.

Wrong polarity may damage the unit and void the warranty.

Tilting the Speaker Body up or down

The speaker body can be lifted up to face forward at about a 45 degree angle. Press down on the two Release Buttons located on both sides of the main body to lay the speaker body down flat.

SETTING THE CURRENT TIME

Current Time Setting

When first plugged in the display will show “12:00” after power up. The following example shows the procedure for setting the clock time to 8:20 AM.

1.The dock display will show “12:00” when first plugged in.

5

Image 5
Contents Docking Digital Clock Radio Music System For iPod FCC Notice Important InstructionsLocation of Controls Important NotesProtect Your Furniture Battery Operation Setting UP and ConnectingBattery Care Battery ReplacementActivating the Backup Function Setting the Current TimeTo Receive Preset Stations To Preset ChannelsTuner Operation PressTips for Best Reception AUX OperationAlarm Time Setting Alarm OperationTo place the iPod adapter To remove/replace the iPod adapterWake to Alarm Setting Wakeup ModeWake to Radio Wake to iPodTurning the Lamp On/Off Stopping the AlarmSleep Operation Troubleshooting Guide Care and MaintenanceGeneral SpecificationsAudio Section AccessoriesTuner Section JEN