Hints for the Best Reception

3.) To automatically search for stations with strong signals, press and hold either

the or button until the frequency read out on display begins to scan then release the button. The tuner will stop on the first strong station signal it finds.

4.) Adjust the sound level by pressing the VOLUME + / - buttons.

5.) Press the TIMER button to show the current time on the display. The time will revert back to the station frequency readout after 5 seconds.

Notes:

•Manual tune to select weaker stations that might be bypassed during automatic tuning.

•If the automatic tuning does not stop on the exact frequency of the station, for example, it stops on 100.9 MHz instead of 100.8 MHz, use the manual tuning method to "fine tune" to the exact frequency of the desired station.

•If a station is broadcasting in Stereo, the unit will automatically receive the stereo broadcast.

•To obtain the best FM/FM Stereo reception, unwrap and fully extend the FM Antenna and adjust the position of the wire for best station reception.

Setting the Radio Station Presets

The unit allows you to store up to 10 FM stations for easy recall at any time.

1.) In the FM mode, tune to the radio station you want to store in memory using

	the		or		buttons.

2.)	Press the MEM button. The preset channel number "P01" will be flashing on
	display.
3.) To		change		the preset channel number location, press the MEM-UPor
	MEM-DOWNbuttons to step through the preset locations (P01 – P10).
4.)	To confirm the preset location, press the MEM button.
5.)	To store up to 10 FM station presets, repeat steps 1 to 4 above.

Note:

1.There is a 5 seconds delay when programming, after 5 seconds, the unit will automatically switch back to normal tuner mode.

2.You can overwrite a present station by overwriting and storing the new frequency in its place.

Recall Preset Radio Stations

1.) Set the unit to FM mode.

2.) Press the MEM-UPor MEM-DOWNbutton to select preset channel.