Model ST-865M3 SmarTrunk IITM Logic Board
The System Operator/Manager activates a subscriber (individual or group) by programming the
An individual Subscriber ID Number and associated Paging Code are numbers assigned to one subscriber. The subscriber may be called as an individual by other subscribers or from the landline. Calls made by and to the individual subscriber are accounted for and recorded by the ST- 852M SmarTrunk II controller.
A group Subscriber ID Number and associated Paging Code are numbers assigned to more than one subscriber. These grouped subscribers will receive a common alert if the Subscriber ID Number is called from another radio subscriber or from the landline. This signalling is commonly used for dispatch/fleet radio operation. Calls made by and to any subscriber in the group are accounted for and recorded by the
Example #1: If a subscriber is only a radio telephone user, the Pri- mary Code is programmed for the Paging Code associ- ated with the Subscribers ID Number. When the sub- scriber has no need for radio group calling, the Sec- ondary Code should be programmed with the same number as the Primary Code. In this case, the SmarTrunk II subscriber equipment operates similar to single line telephone.
Example #2: If a subscriber has a requirement to operate radio tele- phone and radio group calling, the individual Paging Code is assigned to the Primary Code and the group Paging Code assigned to the Secondary code. The op- erator of this equipment, can receive and initiate indi- vidual calls to and from other subscribers and the landline. Additionally, this equipment can be contacted as part of the radio group.
20