Motorola GP68 operation manual Automatic PTT Mode, Emergency Call Override

Page 37

4 • ST-865M3 Programming

To program the ST-865M3 with a trunking system ID number: Enter the program code 20 followed by the # key, and then the trunking system ID number followed by the # key.

Example: To program the Trunking System ID

Number to 5 press: 2 0 # 5 #.

4.2.8Automatic PTT Mode

The Automatic PTT mode makes radio operation simple for the dispatch operation. With this mode enabled, the subscriber simply presses the PTT switch on the radio to gain channel access. The ST-865M3 will automati- cally call the subscriber’s Secondary code for fleet-dis- patch type trunking systems. No keypad entry is re- quired to operate in this mode.

Note: This option should not be used if the primary function of a subscriber is for radiotelephone. Both radiotelephone and fleet-dispatch mobiles can share the same trunking system.

To program the automatic PTT mode: Enter the pro- gram code 21 followed by the # key, and then either 1 (enable) or 0 (disable) followed by # key.

Example: To enable automatic PTT mode press: 2 1 # 1 #.

4.2.9Emergency Call Override

When a subscriber places an emergency call by using routing code 0 (pressing *0), the ST-865M3 will dial the pre-programmed emergency phone number on line 1. If all channels are busy and Emergency Call Override is enabled, it will automatically begin a priority call over- ride function to dial the emergency phone number. See the ST-852M SmarTrunk II Digital Trunking Control- ler manual for details on programming the emergency phone number.

To program the Emergency Call Override feature: Enter the program code 22 followed by the # key, and then either 1 (enable) or 0 (disable) followed by the # key.

Example: To enable Emergency Call Override press: 2 2 # 1 #.

37

Page 36 Page 38
Image 37
Page 36 Page 38
Contents SmarTrunk Systems, Inc. ST-865M3 Motorola P/N PMLN4066A Warranty Policy Contents Programming Feature Descriptions Installation of the Logic BoardEntering The Program Mode PortableRadioProgrammingFigures This page left blank intentionally Introduction Viii Landline To Subscriber Call OperationCall Routing Codes For Subscriber Initiated Calls Routing Code Destination Conventional ModeSubscriber To Landline Call Subscriber To Subscriber CallMobile Operator Call Originating a CallEmergency Call Store And Send Dialing Dialing Mode ProcedureProgramming Memory Speed Dial Numbers Memory Speed DialingPriority Call Override RedialClear Channel Alerting Call TerminationRadio-Kill Page Subscriber ID Numbers/Paging Code Numbers Operating ModesModel ST-865M3 SmarTrunk Iitm Logic Board Operating Modes Primary Code Secondary Code 4100 4101 4103 4102 4104 Disassemble Radio Installation for GP68Slide Battery Latch Model ST-865M3 SmarTrunk II Logic Board Remove BatteryRemove Radio Chassis Installation For GP68 Remove Radio’s ChassisModel ST-865M3 SmarTrunk II Logic Board Installation of the ST-865M3 Logic BoardReassemble Radio Installation For GP68Replace Radio’s Chassis Page Troubleshooting Repair Radio Trouble ShootingSystem Tone Portable Radio ProgrammingLogic Board Programming Entering The Program ModeNumber of Trunking Channels ST-865M3 Programming Primary Code Priority Subscriber EnableSecondary Code Five Digit Access Code Trunking System ID Number Return To Radio Default ValuesEmergency Call Override Automatic PTT ModeRadio-Kill Clear Channel Alerting ModeMemory Speed Dial Programming Conventional Operating Mode Page Appendix a Programming Worksheet Model ST-865M3 SmarTrunk Logic Board Appendix B Cross Reference Chart Model ST-865M3 SmarTrunk Logic Board
Top Page Image Contents