Motorola GP68 operation manual Logic Board Programming, Entering The Program Mode

Page 31

4 • LOGIC BOARD PROGRAMMING

The ST-865M3 provides the installing technician a flexible programming capability after the ST-865M3 has been installed in the radio. The ST- 865M3 is programmed by using the keypad on the front of the radio. No special cables or other attachments are required. All programming information

is retained in a non volatile EEPROM.

To test the installation and programming of the ST-865M3, a functional ST- 852M with the system ID numbers and paging codes correctly programmed is required. See the ST-852M SmarTrunk II Digital Trunking Controller manual for details on adding subscriber ID numbers to the system.

4.1Entering The Program Mode

To enter the programming mode, perform the following steps:

a.Turn the radio off.

b.Press and hold the # key on the front panel keypad.

c.Turn the radio on.

d.After the beep is heard, release the # key.

e.Enter the dealer programmed 5 digit access code, followed by the

# key. The default access code is 12345.

f.The ST-865M3 will respond with a high beep. If a low beep is heard, the access code was incorrect. Turn the radio off and try the procedure again.

4.2Programming Feature Descriptions

The ST-865M3 programming features are described herein. A programming worksheet is provided in Appendix A. This worksheet should be copied and filled out for each subscriber and used as a record of the programming for that particular subscriber.

31

Image 31

Contents SmarTrunk Systems, Inc. ST-865M3 Motorola P/N PMLN4066A Warranty Policy Contents PortableRadioProgramming Installation of the Logic BoardProgramming Feature Descriptions Entering The Program ModeFigures This page left blank intentionally Introduction Viii Landline To Subscriber Call OperationCall Routing Codes For Subscriber Initiated Calls Subscriber To Subscriber Call Conventional ModeRouting Code Destination Subscriber To Landline CallMobile Operator Call Originating a CallEmergency Call Store And Send Dialing Dialing Mode ProcedureProgramming Memory Speed Dial Numbers Memory Speed DialingPriority Call Override RedialClear Channel Alerting Call TerminationRadio-Kill Page Subscriber ID Numbers/Paging Code Numbers Operating ModesModel ST-865M3 SmarTrunk Iitm Logic Board Operating Modes Primary Code Secondary Code 4100 4101 4103 4102 4104 Disassemble Radio Installation for GP68Slide Battery Latch Model ST-865M3 SmarTrunk II Logic Board Remove BatteryRemove Radio Chassis Installation For GP68 Remove Radio’s ChassisModel ST-865M3 SmarTrunk II Logic Board Installation of the ST-865M3 Logic BoardReassemble Radio Installation For GP68Replace Radio’s Chassis Page Troubleshooting Repair Radio Trouble ShootingSystem Tone Portable Radio ProgrammingLogic Board Programming Entering The Program ModeNumber of Trunking Channels ST-865M3 Programming Primary Code Priority Subscriber EnableSecondary Code Five Digit Access Code Trunking System ID Number Return To Radio Default ValuesEmergency Call Override Automatic PTT ModeRadio-Kill Clear Channel Alerting ModeMemory Speed Dial Programming Conventional Operating Mode Page Appendix a Programming Worksheet Model ST-865M3 SmarTrunk Logic Board Appendix B Cross Reference Chart Model ST-865M3 SmarTrunk Logic Board