Graco 24R200 operation manual Route the Power Cord and Signal Cable to the Junction Box

Page 11

Installation

9. Route the Power Cord and Signal Cable to the Junction Box.

Secure the power cord and signal cable to the base (A) cross bar.

Routing

10.Connect the Leads in the Junction Box.

Connect “A” leads, “B” leads, ground, and signal cable within the junction box. Replace the cover.

332511A

11

Image 11

Contents Heated Platen Kit Related Manuals Contents System Description Power RequirementsOverview Heated Platen Kit Component Identification70 1 2 Heat ControllerGrounding InstallationAccess the Platen Connect the Ground Wires Install the Heat Coils and the Thermostat SwitchMount the RTD Connect the Power LeadsAttach the Platen Covers Mount the Heat Electrical Panel on the 5 Gallon 19 liter Ram Mount the Junction BoxConnect the Leads in the Junction Box Route the Power Cord and Signal Cable to the Junction BoxInstallation Setup Shutdown OperationStartup Platen Maintenance MaintenanceCommon Problems TroubleshootingProblem Cause Verification Solution Replace Platen Heaters and Sensor RepairSchematic Heated Platen Kit, 24R200 PartsParts 332511A Part Description Quantity WASHER, M6 Heat Module Heat Enclosure, 24R870117 130 118 114 124 126 102 104 120 Part Description Quantity Parts 332511A Graco Information Graco Standard Warranty