Graco 24R200 operation manual Attach the Platen Covers

Page 9

Installation

6. Attach the Platen Covers.

NOTICE

To prevent damage to wires, ensure wires are not pinched when assembling and securing platen cov- ers.

NOTE: Torque the platen cover fasteners to

60+/- 10 in-lbs (6.8 +/- 1.1 N•m).

-(1) Conduit

-(1) Fastener

- (1) Fastener

- (1) Plug

- (2) Covers

332511A

9

Image 9

Contents Heated Platen Kit Related Manuals Contents Power Requirements OverviewSystem Description Heated Platen Kit Component Identification70 1 2 Heat ControllerInstallation Access the PlatenGrounding Connect the Ground Wires Install the Heat Coils and the Thermostat SwitchMount the RTD Connect the Power LeadsAttach the Platen Covers Mount the Heat Electrical Panel on the 5 Gallon 19 liter Ram Mount the Junction BoxConnect the Leads in the Junction Box Route the Power Cord and Signal Cable to the Junction BoxInstallation Setup Operation StartupShutdown Platen Maintenance MaintenanceCommon Problems TroubleshootingProblem Cause Verification Solution Replace Platen Heaters and Sensor RepairSchematic Heated Platen Kit, 24R200 PartsParts 332511A Part Description Quantity WASHER, M6 Heat Module Heat Enclosure, 24R870117 130 118 114 124 126 102 104 120 Part Description Quantity Parts 332511A Graco Information Graco Standard Warranty