Warnings
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama- tion point symbol alerts you to a general warning and the hazard symbols refer to
WARNING
ELECTRIC SHOCK HAZARD
This equipment must be grounded. Improper grounding, setup, or usage of the system can cause electric shock.
•Turn off and disconnect power at main switch before disconnecting any cables and before servicing or installing equipment.
•Connect only to grounded power source.
•All electrical wiring must be done by a qualified electrician and comply with all local codes and regulations.
BURN HAZARD
Equipment surfaces and fluid that’s heated can become very hot during operation. To avoid severe burns:
•Do not touch hot fluid or equipment.
Overview
System Description
The heated platen kit is a field installed kit to add heat to the platen. The additional heat may change the viscosity properties of the material and allow the material to flow easier through the system.
Power Requirements
A 25A (minimum) - 30A (maximum) circuit breaker must be installed on the incoming power supply.
Nominal Voltage** | Wattage | Amps* |
|
|
|
240 V | 3,500 per Platen | 20 |
|
|
|
*Add to power requirements of ExactaBlend AGP Advanced Glazing Proportioner system. Amps maxi- mum per leg shown.
**
332511A | 3 |