AE/LZB 119 1902 R1A
Figure 13
10.Using a flat blade screwdriver, push on the battery contacts. Be careful not to damage the gasket. Applying pressure on the battery contacts will slowly separate the main circuit board and shield from the metal frame.
Figure 13 - Push Battery Contacts
Figure 14
11.Carefully unplug the small flex at the top of the radio (F).
NOTE
This connector is not keyed. When replacing be careful to plug back properly.
Figure 15
12.Remove the board from the shield by prying up on a corner and working around the board to release the snaps.
Figure 15 - Separating Board From Shield
Figure 16
13.To remove the switch assembly use a small flat blade screw driver and pry up on the bottom latch.
F 
Figure 14 - Board/Shield Separated From Metal Frame
Figure 16 - Removing the Switch Assembly (Pry up on bottom latch)
29