
AE/LZB 119 1902 R1A
Flash Programming
The “FLASH” software is the current version of the
Programming Mode
The PC Programmer cannot communicate with the radio unless the radio is in the Programming Mode. To place the radio in Programming Mode:
1.Initially the radio should be OFF.
2.Press and hold the PTT, Monitor and Clear buttons.
3.Power the radio ON. Release the buttons.
4.All pixels on the display should be lit until communication with the PC begins.
BASIC TROUBLESHOOTING
The objective of this section is to guide in quickly isolating a problem to either hardware or software. Software errors and problems can usually be corrected in the field. Hardware failures are difficult to isolate and sometimes very tedious to repair without specialized tools. As stated previously, hardware repair to this radio is very limited at best and not recommended. Service Parts has set up a Repair and Return policy. Service Parts has also made provisions for Circuit Board and Module replacement as required.
This section includes a General Troubleshooting Table and Test Point Diagram for checking Nominal Transmit/Receive Levels (not recommended). Start by following Table 1 - General Troubleshooting and then use the remaining reference material as needed.
Figure 7 - Programming And Test Equipment Setup
19