RIDGID R8408 manual Using AN iPod with the Job-site radio/ race scanner, pin Connectors IPod

Page 20

OPERATION

USING AN iPod WITH THE Job-site radio/ race scanner

See Figures 22 - 24.

FOR DOCKABLE iPods (with 30-pin connector):

Select AUX 1 MODE.

Open the drop-down compartment door by pulling up on the latch handle.

Orient the iPod face up as shown and slide the unit under the retainer strap.

Make sure that the 30-pin connector on the iPod is aligned with the 30 pin connector in the door and that the iPod is pushed down completely to ensure proper docking.

The iPod must be ON and in PLAY mode for sound to be heard through the speakers.

The iPod will recharge while playing. The iPod will recharge when docked, even if the radio power is OFF.

All iPod controls can be used normally while the unit is docked, with the exception of the volume. Volume is controlled through the volume control knob on the radio.

Turning the radio OFF while the iPod is docked will NOT turn the iPod OFF.

To remove the iPod from the dock, simply pull upward to disconnect.

To protect the iPod from environmental hazards such as dust, moisture, etc., the drop-down compartment door must be closed and latched.

For complete operating instructions for the iPod, always refer to the manual that was included with your iPod model.

LCD DISPLAYS

AUX 1 MODE

Fig. 22

RETAINER

STRAP

30-pin

connectors

iPod

Fig. 23

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents OPERATOR’S Manual Table of Contents IntroductionGeneral Safety Rules Important Safety Instructions Electrical SafetyPersonal Safety Heed ALL Warnings Follow ALL InstructionsSpecific Safety Rules ServiceSymbols Symbol Name DESIGNATION/EXPLANATIONCord Length Wire Size A.W.G ElectricalDouble Insulation Electrical ConnectionFCC Compliance FeaturesProduct Specifications Digital Clock Race ScannerBacklit LCD Display Protective Steel Roll Cage Squelch ControlTOP Tray Assembly OperationUnpacking Packing ListCharger and Battery Packs Sold Separately To install/REPLACE clock/MEMORY batteriesGeneral Usage Tips CordTo INSTALL/remove Battery Pack LatchesReceptacle Dc 1-amp ReceptacleWIRE-STYLE FM Antenna Optional Adjusting the volumeLCD display Turning the radio on/offSeek/scan AM & FM Modes Mode SelectionManual tuning all modes Storing a preset in Memory Direct tuneSetting the clock Stereo/monoBass boost Fm only Bass Boost Hour h Minute mPreset Scan Mode Race Specific FeaturesNormal Scan and Preset Scan Modes Clearing Race Presets To clear a preset Race channel from memorySkipping Frequencies and Presets Squelch controlUsing AN iPod with the Job-site radio/ race scanner 30-pin Connectors IPodLCD Displays UX 2 Mode Maintenance General MaintenanceBattery Pack Removal and Preparation for Recycling BatteriesRace LOCATION/DATE Driver/Car No Frequency PresetTrackside Planner Trackside Planner Warranty DAY Satisfaction Guarantee PolicyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredCustomer Service Information Model No R8408 Serial No
Top Page Image Contents