RIDGID R8408 manual LCD Displays UX 2 Mode

Page 21

OPERATION

FOR NON-DOCKING iPods, OTHER MP3 PLAYERS, AND CD PLAYERS:

Select AUX 2 MODE.

Open the drop-down compartment door by pulling up on the latch handle.

Make sure the iPod/MP3 player will fit inside the compartment provided.

NOTE: CD players will not fit.

The retainer strap may be used to secure the iPod/MP3 player into position.

CD players can simply be placed on the foam padding on the inside of the compartment door. The compartment door cannot be closed when a CD player is connected.

Connect one end of a 3.5 mm audio patch cord (maximum 8 in. long) to the iPod/MP3/CD player.

Connect the other end of the 3.5 mm patch cord to the AUX 2 jack provided.

Make sure that the audio patch cable is positioned so that it is not pinched if the door is closed.

The iPod/MP3/CD player must be ON and in PLAY mode for sound to be heard through the speakers.

All iPod/MP3/CD player controls can be used normally while connected to radio.

NOTE: Volume for any device connected through the AUX 2 jack is adjusted using the volume control for that device.

Turning the radio OFF will NOT turn the iPod/MP3 player OFF.

To protect the iPod/MP3 player from environmental hazards such as dust, moisture, etc., the drop-down compartment door must be closed and latched.

The AUX 2 jack DOES NOT provide charging function.

For complete operating instructions for all iPod, other MP3 players, and CD players, always refer to the manual that was included with your model.

Most CD players are too large to fit inside the internal compartment. To use these devices, open the drop-down compartment door to access the AUX 2 input jack, and connect the device as described above. Turn on the CD player and adjust the volume to the desired level.

LCD DISPLAYS

AUX 2 MODE

3.5 mm AUDIO

 

 

PATCH CABLE

 

 

(INCLUDED)

RETAINER

iPod OR OTHER

 

 

MP3 PLAYER

 

STRAP

 

 

 

 

Fig. 24

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents
OPERATOR’S Manual Introduction Table of ContentsElectrical Safety General Safety Rules Important Safety InstructionsPersonal Safety Heed ALL Warnings Follow ALL InstructionsService Specific Safety RulesSymbol Name DESIGNATION/EXPLANATION SymbolsElectrical Cord Length Wire Size A.W.GDouble Insulation Electrical ConnectionFeatures Product SpecificationsFCC Compliance Race Scanner Backlit LCD DisplayDigital Clock Squelch Control TOP TrayProtective Steel Roll Cage Operation AssemblyUnpacking Packing ListTo install/REPLACE clock/MEMORY batteries Charger and Battery Packs Sold SeparatelyGeneral Usage Tips CordLatches To INSTALL/remove Battery PackReceptacle Dc 1-amp ReceptacleAdjusting the volume WIRE-STYLE FM Antenna OptionalLCD display Turning the radio on/offMode Selection Manual tuning all modesSeek/scan AM & FM Modes Direct tune Storing a preset in MemoryStereo/mono Setting the clockBass boost Fm only Bass Boost Hour h Minute mRace Specific Features Normal Scan and Preset Scan ModesPreset Scan Mode To clear a preset Race channel from memory Clearing Race PresetsSquelch control Skipping Frequencies and Presets30-pin Connectors IPod Using AN iPod with the Job-site radio/ race scannerLCD Displays UX 2 Mode General Maintenance MaintenanceBattery Pack Removal and Preparation for Recycling BatteriesDriver/Car No Frequency Preset Trackside PlannerRace LOCATION/DATE Trackside Planner DAY Satisfaction Guarantee Policy WarrantyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredModel No R8408 Serial No Customer Service Information
Related manuals
Manual 26 pages 854 b