Uniden uh065sx-2 Keypad Lock, Back Lighting, To prevent accidental entries, you can lock

Page 24

UNIDEN Model uh065sx UHF CB Radio

OPERATION

BATTERY SAVE

Battery Save feature extends the battery life by switching the receiver circuit power ON and OFF. This feature automatically activates during stand by mode (RX mode without signal). It turns OFF automatically when a signal is present, and activates again after channel inactivity. Battery Save can be switched on or off.

1.Press MENUENT eleven times. bS setting flashes.

2.Press or to change selection.

3. Press and hold MENU to save and exit.

ENT

KEYPAD LOCK

To prevent accidental entries, you can lock

the keypad. Press and hold the button for 1.5 Secs until it beeps to activate Key

Lock. Theicon appears.

To unlock the keypad, press and hold

button again for 1.5 Secs. Theicon disappears.

When the Key Lock is active, an error tone will be heard if you attempt to press the keys.

BACK LIGHTING

The Liquid Crystal Display (LCD) is backlit for easy viewing at night or in low light situations. The back lighting automatically switches ON every time a key (except PTT) is pressed. It turns OFF 5 secs after the last key is pressed.

23

uh065sx OM.indd Sec1:23

17/8/07 3:00:34 PM

Image 24
Contents Uh065sx uh065sx-2 Uh065sx OM.indd Sec11 17/8/07 30026 PM Contents Features IntroductionControls & Indicators Microphone Up Button Down Button Speaker Optional Accessories Included in Your Uh065sx PackTo install batteries Make sure your radio is OFF Getting StartedConnect the AC adaptor to the charging cradle Charging TimeBattery 100% full LevelsAlmost Empty LOW Battery Alert Icon indicates a fully powered unitPower ON/OFF VolumeSetting the Squelch OperationPower of uh065sx is 2 Watts Selecting a ChannelTo Transmit and Receive Press or to select the desired channelTo Operate in Duplex Mode Repeaters You can only activate Duplex on CH01-CH08Transmit Power Select TX Power Low TX Power MiddleScanning Example. CH40 becomes active When is pressed during To initiate scanningSetting flashes Press Menu three times. PRIPress and hold Menu to Select the channel you want to store by pressing orDisplay when activated Dual WatchMonitor To use monitorCurrent DCS/CTCSS setting Flashes CtcssDCS Select desired channel Press and hold MEM .TheCurrent vox setting flashes VOXRoom Monitor Press and hold Menu to save ExitRoom Monitor can be temporarily disabled by pressing or When is pressed momentarilyTo select desired setting Call ToneBusy Channel Lockout Roger BeepKEY Beep However, Roger Beep will not be heard from the speakerKeypad Lock Back LightingTo prevent accidental entries, you can lock Simplex Mode Duplex Mode UHF CB Channels & FrequenciesCtcss & DCS Code List Warranty Warranty only available in original country of purchaseUniden Australia Pty Limited/Uniden New Zealand Limited