Uniden uh065sx-2 owner manual Transmit Power Select, Scanning, TX Power Low TX Power Middle

Page 15

UNIDEN Model uh065sx UHF CB Radio

OPERATION

TRANSMIT POWER SELECT

The uh065sx has three transmit power levels: 2 Watt, 0.5 Watt and 0.1 Watt. To change your transmit power level:

1.Press while in the ’power middle level’ to change to ’power high level.’

2.Press while in the ’power high level’ to change to the ’power low level.’

3.Press while in the ’power low level’ to change to ’power middle level.’

TX Power Low

TX Power Middle

TX Power High

Transmitting on a higher level will use more Battery power but will enable you to transmit further.

SCANNING

The uh065sx has two types of scanning; Open Scanning (OS) and Group Scanning (GS), OS Scan searches all the channels and frequencies in its memory continu- ously. GS Scan has the ability of monitoring a priority channel every 1.5 seconds while searching channels and frequencies in

its memory.

Scanning allows you to search for active channels programmed in the OS or GS memory.

To initiate scanning,

1. Assuming the unit is on CH01 when switched on.

2. Press and scanning starts.

DUAL

Scan icon flashes during scanning.

14

uh065sx OM.indd Sec1:14

17/8/07 3:00:31 PM

Image 15
Contents Uh065sx uh065sx-2 Uh065sx OM.indd Sec11 17/8/07 30026 PM Contents Introduction FeaturesControls & Indicators Microphone Up Button Down Button Speaker Included in Your Uh065sx Pack Optional AccessoriesGetting Started To install batteries Make sure your radio is OFFCharging Time Connect the AC adaptor to the charging cradleBattery 100% full LevelsAlmost Empty Icon indicates a fully powered unit LOW Battery AlertOperation Power ON/OFFVolume Setting the SquelchPress or to select the desired channel Power of uh065sx is 2 WattsSelecting a Channel To Transmit and ReceiveYou can only activate Duplex on CH01-CH08 To Operate in Duplex Mode RepeatersTransmit Power Select TX Power Low TX Power MiddleScanning Example. CH40 becomes active To initiate scanning When is pressed duringSelect the channel you want to store by pressing or Setting flashesPress Menu three times. PRI Press and hold Menu toTo use monitor Display when activatedDual Watch MonitorSelect desired channel Press and hold MEM .The Current DCS/CTCSS setting FlashesCtcss DCSPress and hold Menu to save Exit Current vox setting flashesVOX Room MonitorCall Tone Room Monitor can be temporarily disabled by pressing orWhen is pressed momentarily To select desired settingHowever, Roger Beep will not be heard from the speaker Busy Channel LockoutRoger Beep KEY BeepKeypad Lock Back LightingTo prevent accidental entries, you can lock UHF CB Channels & Frequencies Simplex Mode Duplex ModeCtcss & DCS Code List Warranty only available in original country of purchase WarrantyUniden Australia Pty Limited/Uniden New Zealand Limited