RoomLink User Guide
About Power Connections
RoomLink does not start or operate
❑Connect the AC adapter securely. The standby indicator light is red (dimmed) after the AC power cord is connected between the network media receiver unit and the wall power outlet.)
❑Verify that all cables are connected securely.
❑If you are using a power cord extension, power strip, or surge suppressor, make sure that it is turned on and securely connected to the wall power outlet.
❑Verify that the fresh batteries are properly installed in the Remote Commander® unit.
❑Unplug the AC adapter from the power outlet and plug it again. Doing so resets RoomLink™ to the original factory default settings.
The RoomLink™ unit takes approximately 20 seconds to start, after connecting to AC power. If the unit’s standby indicator does not light within 20 seconds, the network media receiver may be damaged.
The RoomLink unit doesn’t turn off
❑If the displayed screen is frozen or unresponsive, or you cannot turn the network media receiver off, the unit may have become unstable.
To reset the unit:
1Press the POWER button on the network media receiver for more than five seconds or disconnect the AC adapter from the network media receiver.
2Wait 20 seconds for the standby indicator to light in red, then turn the network media receiver unit on.
Resetting the network media receiver or reconnecting the AC adapter resets the unit’s settings to the original factory default settings.
❑To completely disconnect power to the network media receiver, unplug the AC adapter.
✍RoomLink goes into Standby mode and the standby indicator light is red (dimmed).
112 |
