About Connecting to a Server

Visual and audio reception is interrupted or distorted

The network may not have enough bandwidth.

Check the following, if applicable to your network environment:

The network cables supports 100 BASE-TX.

The network switch or the router device supports 100 BASE-TX.

The connected server or the network may be experiencing overload.

Using the High Quality setting in the Live Mode of the TV Settings screen may cause your network or system to overload. Try changing the Live Mode setting to Standard or Low Bandwidth.

About Connecting to a Server

Cannot connect to a server*

Verify that the VAIO® computer(s) is turned on.

Verify that the network settings are configured correctly.

Check the following, if applicable to your network environment:

A crossover cable is used for a direct connection between RoomLink™ and a single VAIO computer.

The network switch or the router device is turned on. (See the information supplied with your network switch or router device, for details.)

The router device is turned on before turning on the network media receiver.

The network media receiver, network switch, or router device are properly connected using the appropriate network cables.

If using a router device, RoomLink™ and the VAIO computer have been configured to obtain the IP address automatically.

Verify that the correct server name appears in the Select a server screen. (The Select a server screen lists all current and previous servers connected to RoomLink).

*You may see an error message, “Cannot connect to the server.”

† Use network cables that support 100BASE-TX.

115

Page 115
Image 115
Sony PCNA-MR10 manual About Connecting to a Server, Visual and audio reception is interrupted or distorted