Uniden uh065sx-2 owner manual Busy Channel Lockout, Roger Beep, KEY Beep, Press

Page 23

UNIDEN Model uh065sx UHF CB Radio

OPERATION

BUSY CHANNEL LOCKOUT

BCL is used when CTCSS or DCS is selected to prevent transmission when the uh065sx detects a transmission from another unit using the same CTCSS or DCS code.

1.Press MENUENT eight times. The current BCL setting flashes.

2.Press or to select desired setting.

3.Press and hold MENU to save and exit.

ENT

ROGER BEEP

Roger Beep is a BEEP that is sent to notify the end of transmission (both PTT and VOX transmission.) Roger Beep can be heard through the speaker when Key Beep is on. Roger Beep is transmitted even if Key Beep is turned off.

However, Roger Beep will not be heard from the speaker.

1. Press

MENU

nine times. The current Roger Beep setting flashes.

ENT

2.Press or to select desired setting.

3.Press and hold MENU to save and exit.

ENT

KEY BEEP

Assures the user that the keypad has been properly pressed by emitting a beep tone. This tone can be switched on or off.

1.Press MENUENT ten times. bP setting flashes.

2.Press or to change selection.

3.Press and hold MENU to save and exit.

ENT

22

uh065sx OM.indd Sec1:22

17/8/07 3:00:34 PM

Image 23
Contents Uh065sx uh065sx-2 Uh065sx OM.indd Sec11 17/8/07 30026 PM Contents Introduction FeaturesControls & Indicators Microphone Up Button Down Button Speaker Included in Your Uh065sx Pack Optional AccessoriesGetting Started To install batteries Make sure your radio is OFFCharging Time Connect the AC adaptor to the charging cradleAlmost Empty Battery 100% fullLevels Icon indicates a fully powered unit LOW Battery AlertOperation Power ON/OFFVolume Setting the SquelchPress or to select the desired channel Power of uh065sx is 2 WattsSelecting a Channel To Transmit and ReceiveYou can only activate Duplex on CH01-CH08 To Operate in Duplex Mode RepeatersScanning Transmit Power SelectTX Power Low TX Power Middle Example. CH40 becomes active To initiate scanning When is pressed duringSelect the channel you want to store by pressing or Setting flashesPress Menu three times. PRI Press and hold Menu toTo use monitor Display when activatedDual Watch MonitorSelect desired channel Press and hold MEM .The Current DCS/CTCSS setting FlashesCtcss DCSPress and hold Menu to save Exit Current vox setting flashesVOX Room MonitorCall Tone Room Monitor can be temporarily disabled by pressing orWhen is pressed momentarily To select desired settingHowever, Roger Beep will not be heard from the speaker Busy Channel LockoutRoger Beep KEY BeepTo prevent accidental entries, you can lock Keypad LockBack Lighting UHF CB Channels & Frequencies Simplex Mode Duplex ModeCtcss & DCS Code List Warranty only available in original country of purchase WarrantyUniden Australia Pty Limited/Uniden New Zealand Limited