Uniden uh065sx-2 Call Tone, Room Monitor can be temporarily disabled by pressing or

Page 22

UNIDEN Model uh065sx UHF CB Radio

OPERATION

Room Monitor can be temporarily disabled by pressing or .

If no further operation is performed for 45 seconds then the temporary disable mode ends and Room Monitor mode re-activates.

1.Press MENUENT six times.

2.Press or to select desired setting.

The 5 Room Monitor levels are from 1 (High sensitivity) to 4 (Low sensitivity) and Off.

3.Press and hold MENU to save and exit.

ENT

If using this feature as Baby Monitor please note it is not a replacement for regularly checking the safety and security of children.

The operating time is limited to the remaining charge of the battery and is not suitable for continuous overnight use.

If there is any input at EXT SP MIC JACK, Room Monitor automatically turns off.

CALL TONE

Your uh065sx radio is equipped with 5 selectable call tones that will be transmitted

when is pressed momentarily.

1.

Press

MENU

seven times. The current call tone setting flashes.

ENT

2.

Press

 

or

to select desired setting.

 

The 5 call tones are C1, C2, C3, C4 and C5.

3. Press and hold MENU to save and exit.

ENT

Current regulations require calling tones to be restricted to one transmission per minute. If a second transmission is attempted within one minute then an error tone will sound.

21

uh065sx OM.indd Sec1:21

17/8/07 3:00:33 PM

Image 22
Contents Uh065sx uh065sx-2 Uh065sx OM.indd Sec11 17/8/07 30026 PM Contents Features IntroductionControls & Indicators Microphone Up Button Down Button Speaker Optional Accessories Included in Your Uh065sx PackTo install batteries Make sure your radio is OFF Getting StartedConnect the AC adaptor to the charging cradle Charging TimeLevels Battery 100% fullAlmost Empty LOW Battery Alert Icon indicates a fully powered unitSetting the Squelch Power ON/OFFVolume OperationTo Transmit and Receive Power of uh065sx is 2 WattsSelecting a Channel Press or to select the desired channelTo Operate in Duplex Mode Repeaters You can only activate Duplex on CH01-CH08TX Power Low TX Power Middle Transmit Power SelectScanning Example. CH40 becomes active When is pressed during To initiate scanningPress and hold Menu to Setting flashesPress Menu three times. PRI Select the channel you want to store by pressing orMonitor Display when activatedDual Watch To use monitorDCS Current DCS/CTCSS setting FlashesCtcss Select desired channel Press and hold MEM .TheRoom Monitor Current vox setting flashesVOX Press and hold Menu to save ExitTo select desired setting Room Monitor can be temporarily disabled by pressing orWhen is pressed momentarily Call ToneKEY Beep Busy Channel LockoutRoger Beep However, Roger Beep will not be heard from the speakerBack Lighting Keypad LockTo prevent accidental entries, you can lock Simplex Mode Duplex Mode UHF CB Channels & FrequenciesCtcss & DCS Code List Warranty Warranty only available in original country of purchaseUniden Australia Pty Limited/Uniden New Zealand Limited