Uniden uh065sx-2 owner manual Dual Watch, Monitor, Display when activated, To use monitor

Page 19

UNIDEN Model uh065sx UHF CB Radio

OPERATION

Drop-out Delay

While scanning, the uh065sx stops at a busy channel and receives a signal. When the received signal is over, the unit will wait for 3 seconds for the return of the signal, otherwise, the radio resumes scanning.

DUAL WATCH

When Dual Watch function is active, PRI CH is watched every 1.5 seconds.

Press and hold to activate or deactivate Dual Watch. DUAL appears on the

DUAL

display when activated.

MONITOR

This feature enables users to listen in for weak signals on the current channel at the press of a button.

To use monitor,

For continuous listening.

Press

.

A single tone beep will be

heard and the receiver circuit will stay open, letting in both the noise & weak signals.

• Display shows BUSY icon.

• To return to normal receive

mode press .

18

uh065sx OM.indd Sec1:18

17/8/07 3:00:32 PM

Image 19
Contents Uh065sx uh065sx-2 Uh065sx OM.indd Sec11 17/8/07 30026 PM Contents Introduction FeaturesControls & Indicators Microphone Up Button Down Button Speaker Included in Your Uh065sx Pack Optional AccessoriesGetting Started To install batteries Make sure your radio is OFFCharging Time Connect the AC adaptor to the charging cradleLevels Battery 100% fullAlmost Empty Icon indicates a fully powered unit LOW Battery AlertOperation Power ON/OFFVolume Setting the SquelchPress or to select the desired channel Power of uh065sx is 2 WattsSelecting a Channel To Transmit and ReceiveYou can only activate Duplex on CH01-CH08 To Operate in Duplex Mode RepeatersTX Power Low TX Power Middle Transmit Power SelectScanning Example. CH40 becomes active To initiate scanning When is pressed duringSelect the channel you want to store by pressing or Setting flashesPress Menu three times. PRI Press and hold Menu toTo use monitor Display when activatedDual Watch MonitorSelect desired channel Press and hold MEM .The Current DCS/CTCSS setting FlashesCtcss DCSPress and hold Menu to save Exit Current vox setting flashesVOX Room MonitorCall Tone Room Monitor can be temporarily disabled by pressing orWhen is pressed momentarily To select desired settingHowever, Roger Beep will not be heard from the speaker Busy Channel LockoutRoger Beep KEY BeepBack Lighting Keypad LockTo prevent accidental entries, you can lock UHF CB Channels & Frequencies Simplex Mode Duplex ModeCtcss & DCS Code List Warranty only available in original country of purchase WarrantyUniden Australia Pty Limited/Uniden New Zealand Limited