Uniden UH036SX Getting Started, Battery Warning, Battery Installation, Replace the battery cover

Page 3

GETTING STARTED

BATTERY WARNING

To retain the previous user settings, the UH036 will continue to use a small amount of battery power when switched off. To prevent the batteries from

running down, remove them from the radio if the UH036SX will not be used for long periods.

BATTERY INSTALLATION

Your UH036SX radio uses 3 AAA ALKALINE batteries for power. Use only good quality alkaline batteries for maximum life and range. Note: Batteries are not supplied.

OLDNEW

To avoid damage to the unit do not mix old and new batteries.

1.Make sure your radio is off.

2.Remove the battery cover.

3.Insert 3 AAA ALKALINE batteries according to the polarity symbols inside the battery compartment.

4.Replace the battery cover.

2

Image 3
Contents Operating Guide Included in Your UH036SX Package Control & IndicatorsReplace the battery cover Battery WarningBattery Installation Make sure your radio is off Remove the battery coverSlide the belt clip until it snaps into place LOW Battery AlertWater Warning Belt ClipOperation Power ON/OFFVolume Adjusting the KEY BeepsDesired channel Selecting a ChannelTo Transmit and Receive Press channelMaximum Range Reduced Range RangeMonitor Automatic Squelch FeaturePress and hold Volume To return to normal receive mode press Volume OnceTo Operate in Duplex Mode ScanningStarts Press Channel Power Save DROP-OUT DelayUHF Channels & Frequencies Uniden UH036SX UHF CB Radio Warranty