Uniden UH036SX manual To Operate in Duplex Mode, Scanning, Starts Press Channel

Page 9

TO OPERATE IN DUPLEX MODE

Eg. CH1 is being used in your area for repeater use.

Press dup momentarily. The icon appears.

Press dup again to deactivate the duplex operation. UH036SX will return to normal operation.

SCANNING

The scan function scans all channels and stops at an active channel. When the signal stops, scanning resumes.

To initiate scanning,

1.Assuming the unit is on CH1 when switched on.

2.

Press and hold Channel

 

or

 

for 3 seconds and scanning

 

 

starts.

 

 

 

 

3.

Press Channel

or

;

 

 

or

PTT

to cancel scanning.

 

ch/

dup

vol/

scan

 

mon

 

 

mic

If Channel or is pressed while the unit is paused on a channel, scanning will be resumed.

8

Image 9
Contents Operating Guide Included in Your UH036SX Package Control & IndicatorsBattery Installation Battery WarningMake sure your radio is off Remove the battery cover Replace the battery coverWater Warning LOW Battery AlertBelt Clip Slide the belt clip until it snaps into placeVolume Power ON/OFFAdjusting the KEY Beeps OperationTo Transmit and Receive Selecting a ChannelPress channel Desired channelMaximum Range Reduced Range RangePress and hold Volume Automatic Squelch FeatureTo return to normal receive mode press Volume Once MonitorTo Operate in Duplex Mode ScanningStarts Press Channel Power Save DROP-OUT DelayUHF Channels & Frequencies Uniden UH036SX UHF CB Radio Warranty