PRIORITY SCAN CHANNEL
To set a priority scan channel:
1. | Press select/ | momentarily four times while in | |
| standby mode to enter Priority Scan Channel | ||
| mode. The current priority channel will be | ||
2. | indicated. | key to increase or decrease the | |
Press | or | ||
3. | desired channel number. | ||
Press select/ | three times to confirm and exit | ||
| to standby mode. PRI will be displayed when a | ||
| priority channel has been selected. | ||
BCL (Busy Channel Lockout) ON/OFF
BCL is used when CTCSS or DCS is selected to prevent transmission when the uh064sx detects a transmission from another unit using the same CTCSS or DCS code.
To set BCL ON/OFF:
1. | Press select/ | momentarily five times while in | |
| standby mode to enter BCL ON/OFF mode. | ||
2. | The current BCL status will be indicated. | ||
Press | or | key to select ON (on) or OFF (oF). | |
3. | Press select/ | two times to confirm and exit to | |
| standby mode. BCL will be displayed when BCL on | ||
| has been selected. | ||
SCAN CHANNEL MEMORY
To store a channel into Scan Channel Memory:
1.Select desired channel using ch/txp key and 
or 
key.
2.Press and hold mem/SCN key. MEM will appear on the display.
Repeat steps 1 and 2 to clear channel from Scan Channel Memory.
(11)