Uniden UH088sx manual Connections Front Panel

Page 7

UNIDEN UHF CB Transceiver

Controls/Indicators/Connections

CONNECTIONS

FRONT PANEL

23

23.MICROPHONE SOCKET

The microphone plug is inserted into this socket.

BACK PANEL

24

26

25

24.EXTERNAL SPEAKER JACK - used for remote receiver monitoring. When the external speaker is connected, the internal speaker is automatically disconnected. The connecting wire must use a 3.5mm miniature plug only.

25.ANTENNA CONNECTOR - Connect the Antenna here using a standard UHF (PL259) type connector.

26.DC POWER CORD - DC Power is connected to the transceiver through this jack. A power cord is supplied with the transceiver.

5

Image 7
Contents CB Radio Page Contents Tables Uh088sx Controls/Indicators/ConnectionsIndicators Connections Front Panel Introduction FeaturesFront Panel Layout Microphone Layout Included with your uh088sx CB radio Operation Setting the SquelchSelecting a Channel Operating the uh088sx in Duplex Mode Group Scan GS Mode Choosing a Priority Channel Drop-out delayProgramming Scan Channels Channel Seeking Operation Firstly, activate scan mode by pressingContinuous Tone Coded Squelch System Ctcss Outline Selective Calling Optional Selcall PCB RequiredTransmit TablesONE Year Limited Warranty WarrantyPage Page Uniden Australia Pty Limited / Uniden New Zealand Limited Uh064sx-2 Control & Indicators Getting Started Battery InstallationUser Licence Information Installing the Charge CradleBelt Clip LOW Battery AlertBack Light Roger Beep Power ON/OFFVolume Adjusting the KEY BeepsSelecting a Channel Monitor Automatic Squelch FeatureScanning Operation with the aid of a Repeater Press key to select the required Ctcss tone OFF or Ctcss & DCSTransmitting a Call Tone VOXScan Channel Memory Priority Scan ChannelUHF CB Channels & Frequencies Ctcss & DCS Code List Warranty Uniden Australia Pty Limited/Uniden New Zealand Limited