Free standing

With the foldout stand, the Temperature Station can be placed onto any flat surface.

To wall mount

1.Fix a screw (not supplied) into the desired wall, leaving the head

extended out the by about 5mm.

2.Hang the temperature station onto the screw. Remember to ensure that

it locks into place before releasing.

water may. You can mount it outside under an eve of your house or any other suitable place that will keep it out of the sun and rain. Do not wrap the sensor in plastic or seal it in a plastic bag as these can cause condensation problems and substantially reduced accuracy. Please note a sensor in the Sun will provide inaccurate temperature readings.

Before permanently fixing the transmitter wall base, place all units in the desired locations to check that the outdoor temperature reading is receivable. In event that the signal is not received, relocate the transmitter(s) or move them slightly as this may help the signal reception.

CARE AND MAINTENANCE:

•Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit and give inaccurate forecasts and readings.

•When cleaning the display and casings, use a soft damp cloth only. Do not use solvents or scouring agents as they may mark the LCD and casings.

•Do not submerge the unit in water.

•Immediately remove all low powered batteries to avoid leakage and damage. Replace only with new batteries of the recommended type.

POSITIONING THE TEMPERATURE TRANSMITTER:

The Transmitter is supplied with a holder that may be attached to a wall with the two screws supplied. The Transmitter can also be position on a flat surface by securing the stand to the bottom to the Transmitter.

To wall mount:

1. Secure the bracket onto a desired wall using the screws and plastic anchors.

2. Clip the remote temperature transmitter onto the bracket.

Note: In order to get an accurate reading and to prolong the life of your sensor we recommend that you have it in a sheltered area out of the sun and direct rain. Fog and Mist will not affect the sensor, but a soaking in

•Do not make any repair attempts to the unit. Return them to their original point of purchase for repair by a qualified engineer. Opening and tampering with the unit may invalidate their guarantee.

•Do not expose the units to extreme and sudden temperature changes, this may lead to rapid changes in forecasts and readings and thereby reduce their accuracy.

SPECIFICATIONS:
Temperature measuring range
Indoor	:	14.2ºF to +139.8ºF with 0.2ºF / -9.9ºC to +59.9ºC with 0.1ºC resolution
		(“OF.L” displayed if outside this range)
Outdoor	:	-39.8ºF to +139.8ºF with 0.2ºF / -39.9ºC to +59.9ºC with 0.1ºC resolution
		(“OF.L” displayed if outside this range)
Indoor Temperature checking interval			:	every 15 second
Outdoor data checking interval			:	every 4 second
Power Supply
Temperature Station			: 2 x AAA, IEC LR3, 1.5V
Outdoor Temperature Transmitter			: 2 x AA, IEC LR6, 1.5V
				24