G.TIME ALARM
The projection alarm has two separate alarms for time, “ALM1” and “ALM2”. The alarms have a different sound; ALM1 increases in volume after 25 seconds, and again after 50 seconds. ALM2 is a constant volume. The total duration is 96 seconds for each alarm.
1.SETTING THE ALARM
a.Press and hold “ALM1” OR “ALM2” for two seconds until the alarm time is flashing.
b.Press and release “ALM1/HOUR” to advance the hour, and “ALM2/MIN” to advance the minute. The time will display “PM” if set to PM, and nothing if set to AM.
c.The projection alarm will revert to normal operation when no buttons are pressed for 15 seconds. The alarm is now set and activated.
2.ACTIVATING/DEACTIVATING THE ALARM
a.After entering the alarm setting mode,
the alarm is activated (either ALM1 or | Alarm 2 activated |
ALM2). |
|
b. To toggle between activating and |
|
deactivating the alarm, press either the |
|
ALM1 or ALM2 briefly. “(((1)))” or |
|
“(((2)))” will be displayed to the right of |
|
the time display when the alarm is |
|
activated. |
|
c.When the snooze bar is pressed, the display will scroll through the alarm 1 and 2 times in the lower left.
3.TURNING ALARM OFF (WHILE SOUNDING)
a.While either alarm is sounding, press and release the SNOOZE bar to disable the alarm for the set duration (Section II. D.). If the duration is set to “0”, the alarm will be disabled for 24 hours.
b.After the SNOOZE bar is pressed, the lower left will display the time remaining on the snooze. The SNOOZE bar may be pressed at any time to restart the snooze duration.
c.To disable the alarm for 24 hours, press and release any button other than SNOOZE or projection keys.
H.CHANGING DISPLAY MODE (DAY, SECONDS, AND TEMPERATURE)
There are six possible display modes to view the day, seconds, and temperature (remote temperature is constantly displayed). To change the display (starting at the default of Day.Date.Year/Remote Temperature):
1.Press and release the “MODE/+” button. The display should now show month.day.year/remote temperature
2.Press and release the “+” button a second time and the display will now show seconds/remote temperature
3.Press and release the “+” button a second time and the display will now show alarm1 time/remote temperature
4.Press and release the “+” button a second time and the display will now show alarm2 time/remote temperature
5.Press and release the “+” button a second time and the display will now show indoor temperature/remote temperature
6.Press and release the “+” button a second time and the display will now show day.month.date/remote temperature
11