TROUBLESHOOTING
Problem: | The Projection is faint | |
Solution: | 1) | Change intensity setting |
| 2) | Use AC adapter |
| 3) | Darken surroundings |
| 4) | Use fresh batteries (if AC is not used) |
Problem: | The LCD is faint. | |
Solution: | 1) | Replace the batteries. |
Problem: | “OFL” appears in the indoor temperature LCD. | |
Solution: | 1) | Move unit to an area with warmer or cooler surrounding |
| temperature. Current surrounding temperatures are outside | |
| measuring range. | |
Problem: | No reception of WWVB signal. | |
Solution: | 1) | It may help reception to face the front of the projection alarm in the |
|
| general direction of Ft. Collins, Colorado. |
| 2) | Wait overnight for signal. |
| 3) | Be sure the projection alarm is at least 6 feet from any electrical |
|
| devices, i.e. TV sets, computers, or other radio controlled clocks. |
| 4) | Remove batteries for five minutes, reinsert and leave the unit alone |
|
| overnight without pressing buttons. |
| 5) | If problems persist contact La Crosse Technology. |
Problem: | Hour is incorrect (minute and date are correct). | |
Solution: | 1) | Be sure correct time zone and daylight saving time are selected. |
Problem: | ||
Solution: | 1) | Check batteries in remote |
| 2) | If batteries are replaced in remote, the unit must be |
| Remove all batteries, and then follow start up procedure. | |
Problem: | “OFL” appears in the outdoor temperature LCD | |
Solution: | 1) | Remote temperature is out of range. |
| 2) | Check batteries. |
| 3) | Interference from an outside source (cordless telephone, etc.) |
| 4) | Contact La Crosse Technology. |
Note: For any questions not answered, contact La Crosse Technology with the contact information found at the end of this instructional manual.
13