La Crosse Technology WT-5721 instruction manual Projection Alarm

Page 5
Battery
Cover
AC adapter receptacle

DETAILED SET-UP GUIDE

II.BATTERY INSTALLATION

A.REMOTE TEMPERATURE SENSOR

1. Remove the battery cover. Observing the correct polarity, install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems make sure that they do not spring free during installation).

2.Replace the battery cover.

B.PROJECTION ALARM

1.Remove the battery cover.

2.Observe the correct polarity, and install 2 AA batteries.

3.In addition or instead of inserting batteries, the AC adapter can be used. Simply plug the adapter into the receptacle on the underneath of the alarm clock and then plug in adapter.

4. Replace the battery cover.

5. The projector will activate and

remain on if the alarm clock is plugged in. If only batteries are

used, the projector will only be activated when a button is pressed. The projection is a red light, not harmful under normal usage, although care should be taken to not look directly into the light.

Note: After the batteries have been installed a tone will sound, and the LCD (Liquid Crystal Display) will activate. The indoor temperature and the remote temperature will be displayed (within three minutes). Also, the time will appear as “-:--”. The WWVB search is automatically initiated, and a tower icon appears and flashes with the time colon (no tower icon will appear if the WWVB is too weak to be detected, and the time display will remain on “-:--”). While the WWVB search is being conducted various numbers will appear in the time display. After 10 minutes, the projection alarm will either display the WWVB time, or discontinue the search if the time is not found. If the search is cancelled “-:--” will remain in the time LCD. The projection alarm will conduct a WWVB search every hour until the first signal is found. Once the WWVB time is found, a search is automatically conducted nightly at midnight. If the signal is found at midnight, the tower icon will remain, if not, another search will take place every hour (until 6:00 am) until the signal is found successfully. If no signal is found during this period, the tower icon will not appear and the clock will search again at 12:00 am the next night.

5

Image 5
Contents WT-5721 433 MHz Radio Controlled Projection Alarm Table of Contents Features of Projection Alarm Inventory of ContentsQuick SET-UP Guide Do not Press ANY Buttons for 10 MinutesProjection Alarm Time Zone Setting III. Program ModeProgramming Sequence Function ButtonsAdjustable Snooze Time DST Daylight Saving Time SettingTime Setting Date Setting12/24-HOUR Setting RADIO-CONTROLLED Time and Date IV. Features & OperationsProjection of Time AND/OR Remote Temperature EL Backlight Indoor TemperatureRemote Temperature Setting the Alarm Time AlarmACTIVATING/DEACTIVATING the Alarm Turning Alarm OFF While SoundingVI. Maintenance & Care Mounting the Remote Temperature SensorMounting with Screws Mounting with Adhesive TapeSolution TroubleshootingProblem Temperature Specifications for WT-5721Power source Dimensions L x W x HWarranty Information FCC ID OMO-01RX receiver OMO-01TX sensor