La Crosse Technology WS-7213U instruction manual Indoor Weather Station

Page 10

B. INDOOR WEATHER STATION

Note: After the batteries are installed, DO NOT press any buttons for 15 minutes. This may interfere with the signals, causing temperatures to register incorrectly.

1.Remove the battery cover on the backside. To do this, push up and pull out.

2.Observing the correct polarity, install 2 AA batteries.

Battery cover

Battery Compartment

3.Replace battery cover.

4.Wait 15 minutes or until both the indoor and outdoor temperatures are shown on the indoor weather station.

10

Image 10

Contents WS-7213U Wireless 433 MHz Weather Station Table of Contents Inventory of Contents Additional Equipment not included Quick Setup Do not Press ANY Buttons for 15 MinutesPage Page Press and release the SET button once more and you are done Battery Indoor Weather Station II. Setting the Time Features Minimum and Maximum Temperatures Resetting the Minimum and Maximum Temperatures Weather Forecast Page Page Adding Additional Remote TEMP/HUMIDITY Sensors Optional Page Viewing and Operating With Multiple Remote Sensor Units Page Mounting Remote TEMP/HUMIDITY Sensor Weather Station Troubleshooting SolutionPage Page Maintenance and Care Instructions Specifications Measuring Range TemperatureRecommended Page Page Support@lacrossetechnology.com FCC Disclaimer WS-7034U Wireless 433 MHz Temperature Station Topic Philips screwdriver Fresh AAA 1.5V batteries Quick Setup Detailed Setup Guide Battery Installation Battery Cover II. Time Setting the Time IV. Features Minimum and Maximum Temperatures Adding Additional Remote Control Senders Optional Page Page Mounting Remote Control Sender Temperature StationProblem The LCD is faint Solution Maintenance and Care Instructions Measuring Temperatures Temperature check Page Page Support@lacrossetechnology.com FCC Disclaimer