ENGLISH
Troubleshooting
Getting
If a problem should arise, first check the following:
1.Are the connections correct?
2.Is the set being operated as described in the owner’s manual?
3.Are the other devices operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Problem | Cause | Corrective action | Page |
• The disc is placed in upside | • Place the disc in the tray | 3 | |
cannot be played. | down. | correctly. |
|
| • The information recorded is not | • Record correct information | 15 |
| in an audio | that is compatible with to this |
|
| the MP3/WMA/AAC file was | unit. |
|
| not properly recorded. |
|
|
started Basic connections
GDiscH
Problem | Cause |
|
| Corrective action | Page |
The disc fails to rotate. | • The power cord is pulled out | • Insert the power cord plug | 7 | ||
| of the socket. |
|
| into the socket. |
|
| • Power to this unit is not ON. | • Turn the power to this unit | 8 | ||
|
|
|
| ON. |
|
| • The disc is not placed in the | • Place the disc in the disc tray | 3 | ||
| correct position on the disc | correctly. |
| ||
| tray. |
|
|
|
|
| • The disc is placed in upside | • Place the disc in the disc tray | 3 | ||
| down. (The disc is placed in | correctly. |
| ||
| with the label facing down). |
|
| ||
The disc stops rotating | • The disc is dirty. |
|
| • Clean the disc’s surface. | 4 |
in | • The disc is scratched. |
|
| • The disc may be unable to | – |
|
|
|
| be played if it has a lot of |
|
|
|
|
| scratches. |
|
| • The disc is warped. |
|
| • The disc may be unable to be | – |
|
|
|
| played if it is badly warped. |
|
The disc is rotating but | • The amplifier and speakers | are | • Connect the cables correctly. | 7 | |
no sound is heard. | not connected correctly. |
| (See the instruction manual |
| |
|
|
|
| for the amplifier.) |
|
| • The amplifier power is | not | ON. | • Turn ON the power to the | – |
|
|
|
| amplifier. |
|
|
|
|
| (See the instruction manual |
|
|
|
|
| for the amplifier.) |
|
| • The amplifier’s function | or |
| • Switch the amplifier’s | – |
| selector switch is not set to | function or selector switch |
| ||
| “CD” or “AUX” or such (to |
| to “CD” or “AUX” or such |
| |
| whatever you have connected | (to whatever you have |
| ||
| this unit to). |
|
| connected this unit to). |
|
|
|
|
| (See the instruction manual |
|
|
|
|
| for the amplifier.) |
|
| • The amplifier’s volume | control | • Adjust the amplifier volume. | – | |
| is set at the minimum level. | (See the instruction manual |
| ||
|
|
|
| for the amplifier.) |
|
GDisplayH
Problem |
| Cause |
|
|
| Corrective action | Page | |
“OverCurrent” appears | • The voltage able to be |
|
| • The USB memory device is | – | |||
on the display. | supplied from this unit via the | not supported. Please use a |
| |||||
| USB memory device has been | USB memory device with an |
| |||||
| exceeded. |
|
|
|
| operating current that is less |
| |
|
|
|
|
|
|
| than 1 A. |
|
“FAT Error” or “Cluster | • An | unsupported | file | system | • Please use a USB memory | – | ||
Err” appear on the | is being used. USB memory | device formatted with a |
| |||||
display. | device below 128 MB cannot | compatible file system (FAT32 |
| |||||
| be supported. |
|
|
|
| or FAT16) and that has at |
| |
|
|
|
|
|
|
| least 256 MB of memory. |
|
“No File” appears on | • No file able to | be | played | on this | • Check supported formats. | 15, 18 | ||
the display. | unit exists. |
|
|
|
|
|
| |
“DRM Stream” | • This is a file | subject to digital | • Cannot play on this unit | 16, 18 | ||||
appears on the display. | rights management. |
|
| because of unsupported |
| |||
|
|
|
|
|
|
| DRM. |
|
GUSB/iPodH |
|
|
|
|
|
|
|
|
Problem |
| Cause |
|
|
| Corrective action | Page | |
Sound cannot be | • The amplifier and | speakers | are | • Connect the cables correctly. | 14 | |||
heard even when USB | not connected properly. |
|
| (See the instruction manual |
| |||
memory device is |
|
|
|
|
|
| for the amplifier.) |
|
connected. | • The amplifier power is not | ON. | • Turn the amplifier power ON. | – | ||||
|
|
|
|
|
|
| (See the instruction manual |
|
|
|
|
|
|
|
| for the amplifier.) |
|
| • The | amplifier’s | function | or | • Switch the amplifier’s | – | ||
| selector switch is not set to | function or selector switch |
| |||||
| “CD” or “AUX” or such (to | to “CD” or “AUX” or such |
| |||||
| whatever you have connected | (to whatever you have |
| |||||
| this unit to). |
|
|
|
| connected this unit to). |
| |
|
|
|
|
|
|
| (See the instruction manual |
|
|
|
|
|
|
|
| for the amplifier.) |
|
| • The amplifier’s | volume | control | • Adjust the amplifier volume. | – | |||
| is set at the minimum level. | (See the instruction manual |
| |||||
|
|
|
|
|
|
| for the amplifier.) |
|
Basic operation Advanced connections Advanced operations Explanation of terms Troubleshooting Specifications Index
28