Marantz CD6004 owner manual Discs playable on this unit, Loading discs, Holding discs

Page 6

ENGLISH

Cautions on handling

Before turning the power switch on

Check once again that all connections are correct and that there are

no problems with the connection cables.

• When leaving home for long periods of time, be sure to unplug the

power cord from the power outlet.

Proper ventilation

If the unit is left in a room full of the smoke from cigarettes, etc., for

Discs

Discs playable on this unit

qMusic CDs

Discs marked with the logo at right can be played in this unit.

Loading discs

Make sure the label side (printed side) is facing upwards.

Make sure the disc tray is fully open when inserting the disc.

• Place the discs flat, 12 cm discs in the outer tray guide (Figure 1), 8 cm discs in the inner tray guide (Figure 2).

long periods of time, the surface of the optical pickup may get dirty,

preventing it from receiving the signals properly.

About condensation

If there is a major difference in temperature between the inside of

the unit and its surroundings, condensation may form on parts inside

the unit, causing the unit to fail to operate properly.

If this happens, let the unit sit for an hour or two with the power off

and wait until there is little difference in temperature before using

the unit.

Cautions on using mobile phones

Using a mobile phone near this unit may result in noise. If that

occurs, move the mobile phone away from the unit when it is in use.

wCD-R/CD-RW

NOTE

Discs in special shapes (heart- shaped discs, octagonal discs,

etc.) cannot be played. Do not attempt to play them, as doing so can damage the unit.

Some discs and some recording formats cannot be played.

Non-finalized discs cannot be played.

zzWhat is finalization?

Finalization is the process that makes recorded CD-R/CD-RW discs

Figure 1

Outer tray guide

12 cm disc

Figure 2

Inner tray guide

8 cm disc

Moving the unit

Turn off the power and unplug the power cord from the power outlet.

Next, disconnect the cables connected to other system units before

moving the unit.

playable on compatible players.

Holding discs

Do not touch the signal surface.

Place 8 cm discs in the inner tray guide without using an adapter.

If a DVD or other disc that is not supported by this unit is placed on the disc tray, “SubQ Error” is shown on the display. When the 5 button is pressed after that, the disc tray opens after 60 seconds.

If you place a disc that contains other than MP3 or WMA files, “No File” is displayed.

NOTE

Do not push the disc tray in by hand when the power is turned off. Doing so could damage the set.

Do not place any objects other than discs on the disc tray. Doing so may damage the unit.

Cautions on loading discs

Only load one disc at a time. Loading two or more discs can damage the unit or scratch the discs.

Do not use cracked or warped discs or discs that have been repaired with adhesive, etc.

Do not use discs on which the sticky part of cellophane tape or labels is exposed or on which there are traces of where labels have been removed. Such discs can get caught inside the player and damage it.

3

Image 6
Contents CD6004 NSAFETY Precautions For Canadian customers Avertissements Advertencias Contents Getting startedAccessories Main featuresAbout this manual Loading discs DiscsDiscs playable on this unit Holding discsOperating range of the remote control About the remote controlCleaning discs Inserting the batteriesPart names and functions Front panelDisplay EDIGITAL Audio OUT Optical connector Rear panel Remote controlWDIGITAL Audio OUT Coaxial connector Q0Track skip buttons 8Basic connections Connecting the power cordConnecting cables PreparationsBasic operation Switching the input sourceSet the power to standby Before useChanging the brightness of the display Playback CDsPlaying CDs To change time displayListening with headphone Playing repeatedly Repeat playbackDisplaying CD-TEXT Playing tracks in a specific order Program playback Canceling a track from program playbackCancelling all programmed tracks Checking the program detailsSwitching Audio EX Rewinding tracks slightly to listen again Quick replayTurning digital output off Digital connection Connecting the flasher input jackAdvanced connections Digital audio outputNnSupported iPod Models Remote control connectionNnSetting NnConnectionNWriting software format Advanced operationsPlayable MP3, WMA and AAC formats NFile formatsPlaying MP3, WMA and AAC files MP3, WMA or AAC playback order of MP3, WMA or AAC filesPlayback iPod Buttons that can be used when playing back from an iPodSelecting the operating mode Playing an iPodDisconnecting the iPod Playing a USB memory devicePlayable USB memory formats Fast-forwarding and fast-reversing Searching To switch the folder or file during playbackPlaying files stored on USB memory devices Playing repeatedly Repeat playbackUSB OUT USB audio output settings Performing menu settingsCD D-OUT CD digital output settings Removing the USB memory deviceTimer Play Timer play setting Plays back the Disc mediaUSB/iPod= NnFile Info File information display selection NnRange Spec Playback range selectionNnQ Replay Quick replay USB Setup USB memory device operation NFile Info File information display selectionNnResume Resume playback settings IPod Setup iPod operation NDatabase iPod database selectionNnButtons that can be used when playing back from an iPod Display mode Direct RemoteMP3 Mpeg AudioPlayer Explanation of termsAuto STB Auto standby function Sampling frequencyGDiscH Problem Cause Corrective action TroubleshootingProblem Cause Corrective action GDisplayH ProblemSpecifications Nn Audio performanceIndex VvAPage Unit inch mm Kg 14 lbs 8.8 oz