Craftsman 320.61199 warranty Detachable Vacuum, Adaptor, Attaching the Application Tool , 9, 10

DETACHABLE VACUUM			Fig. 7
ADAPTOR (Fig.7)
Always	connect	the vacuum
adaptor	when	sanding.

Remove the application tool before mounting the vacuum adaptor. To improve dust extraction from the working area, insert the dust-extraction adaptor into the rear of the tool, and connect the adaptor to a

dust-extraction system or a suitable vacuum cleaner.

ATTACHING THE APPLICATION TOOL (FIG. 8, 9, 10, 11)

I

A_, WARNING: Failure to		remove the	battery	pack	from the tool	when
assembling parts,	making	adjustments,	or changing		accessories	could result in
accidental starting	causing	possibly serious		injury.

_, CAUTION: For all work or when changing application tools, always wear protective gloves. The sharp edges of the application tools will cause personal injury. Application tools can be very hot while working.

_, WARNING: Check that the application tools are correctly attached. Incorrect

or insecurely fastened application tools can come loose during operation and cause a hazard.

_, WARNING: Do not attach the circular saw blade or the straight edge cutting blade facing backwards (Fig. 8), as operation in this position may cause serious injury.

1.Remove the battery pack from the Multi-Tool.

2.Loosen the flange bolt with the hex key provided. (Fig. 9)

3.Ensure that the inner threads and the drive shaft are clean.

4.Align the grooves on the application tool with the four raised ribs on the drive shaft; put the application tool onto the drive shaft. (Fig.10)

5.With your gloved hand holding the blade, put on and tighten the flange bolt using the hex key.

NOTE: Attach the application tool at the desired orientation for the task at hand. The shaft is configured so that the application tool can be attached every 30 ° around the shaft, from 0°to 330 ° (Fig. 11).

61199 ManuaLRevised_09 0310 Page 19