SANDING
WARNING: Do not touch the gear box after prolonged use; it could be very hot.
•The removal rate and the sanding pattern are determined by the choice of sanding sheet and the work surface.
•Apply uniform sanding pressure to extend the life of the sanding sheets.
•Intensifying the sanding pressure does not lead to an increase of the sanding capacity, but instead it increases wear on the machine and the sanding sheet.
•Use only the tip or an edge of the sanding sheet for precise sanding of edges, corners and hard to reach areas.
•When selectively sanding on one spot, the sanding sheet can heat up considerably. Remove the tool from the surface periodically to permit the sanding sheet to cool down.
•A sanding sheet that has been used for metal should not be used for other materials.
•Use only original Sears sanding accessories. For sanding, always connect dust extraction.
1.For Rough sanding use
2.For Smooth sanding use
Use the Scraping Blade to:
•remove paint, coatings and vinyl on wood, and other floor coverings
•scrape off adhesive residue
•cut carpet
To cut and remove carpet, place the Scraping Blade vertically on the workpiece, switch the tool on, and cut the carpet, then put the tool on the workpiece at a flat angle (not over 20°), and apply only light pressure. Otherwise the scraper can cut into the surface beneath the carpet.
61199 Manual_Revised_09 | 0310 | Page 22 |