WEEKEND-SLEEPER/ Sleep, Troubleshooting

WEEKEND-SLEEPER/ SLEEP

MAINTENANCE

TROUBLESHOOTING

flash throughout the repeat alarm duration.

•If you are using the CD alarm mode, CD playback resumes at the point interrupted by the repeat alarm.

•During the CD alarm, CD playback continues for up to an hour unless you cancel/ reset the alarm.

WEEKEND-SLEEPER

MAINTENANCE

General (See figure 6)

•	If you do not intend to use the CD clock radio for a long
	time, withdraw the power plug from the wall outlet.
•	Do not expose the set or CDs to humidity, rain, sand
	or excessive heat caused by heating equipment or
	direct sunlight.

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service center.

WARNING:

Do not open the set as there is a risk of electric shock!

Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.

This feature deactivates the alarm every Saturday and Sunday and resumes the alarm function Monday to Friday. Make sure, however, that you have set the day first.

• See chapter on SETTING THE DAY.

1Press WEEKEND-SLEEPERonce or more until ZZ appears for one or both alarms.

2To cancel the weekend-sleeper function repeat step 1 until ZZ disappears from the display. See figure 4.

SLEEP

About Sleep

The CD clock radio has a built-in sleep timer which enables the set to be automatically switched off during radio or CD playback after a set period of time. There are four sleep times before the set turns itself off:

10, 30, 60, 90 minutes and off.

The sleep function does not affect the operation of your alarm settings.

Setting Sleep

1Press PLAY/ PAUSE 2; (CD) or ON/ OFF (radio) to switch on the respective mode.

•For the CD mode, make sure you have inserted a disc first.

2Select your sleep time by pressing SLEEP once or more until the desired sleep time is shown.

See figure 5

3To cancel the sleep function you can either:

–press SLEEP once or more untily SLEEP disappears from the display

–press REPEAT ALARM/ BRIGHTNESS CONTROL

–press STOP 9 (CD only)

–press ON/ OFF (radio only).

• To clean the set, use a soft, slightly dampened

chamois leather. Do not use any cleaning agents

containing alcohol, ammonia, benzene or abrasives

as these may harm the housing.

CD player and CD handling

•The lens of the CD player should never be touched!

•Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates.

•Always shut the CD door to keep the CD compartment dust-free. To clean, dust the compartment with a soft dry cloth.

•To take a CD out of its box, press the center spindle while lifting the CD. Always pick up the CD by the edge and replace the CD in its box after use to avoid scratching and dust.

•To clean the CD, wipe in a straight line from the center towards the edge using a soft, lint-free cloth. Do not use cleaning agents as they may damage the disc.

•Never write on a CD or attach any stickers to it.

Environmental information

All unnecessary packaging material has been omitted to make the packaging easy to separate into three materials: cardboard (box), expandable polystyrene (buffer), polyethylene (bags, protective foam).

Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment.

Problem

Possible Cause

- Remedy

No sound

Volume not adjusted

- Adjust the volume

No reaction to any operation of the buttons

Electrostatic discharge

-Disconnect the set from the power supply and reconnect the set after 5 minutes

•CD PLAYER

CD playback does not work

CD badly scratched or dirty - Replace/ clean CD

Laser lens steamed up

- Wait until lens has acclimatized

Laser lens dirty

- Clean lens by playing a CD lens cleaning disc

CD-R(W) is non-finalized

- Use a finalized CD-R(W)

•RADIO

Occasional crackling sound during

FM broadcast

Weak signal

- Extend pigtail fully

Continuous crackling/

hiss disturbance during AM broadcast

Electrical interference from TVs, computers, fluorescent lamps, etc.

- Move set away from other electrical equipment

•ALARM

The alarm does not function

Alarm time not set

-See chapter on SETTING THE CLOCK AND ALARM TIMES

Alarm mode not selected

- See chapter on SETTING THE ALARM OPTIONS

Volume too low for radio/ CD/ buzzer alarm mode.

- See chapter on Adjusting the Gentle wake volume

•WEEKEND-SLEEPER

WEEKEND-SLEEPER does not function

Day selection not set/ incorrect

- See chapter on SETTING THE DAY

WEEKEND-SLEEPER not set - Set WEEKEND-SLEEPER