Lincoln Electric IM514-A manual Above 60F / 15.5C Summer Season Configuration

Page 15

B-3

OPERATION

B-3

 

 

 

CARBURETOR DEICING KIT USAGE INSTRUCTIONS FOR SEA- SONAL CHANGE OVER

WARNING

ELECTRIC SHOCK can kill.

• Do not operate with panels open.

• Disconnect NEGATIVE(-) BATTERY LEAD before servicing.

• Do not touch electrically live parts.

------------------------------------------------------------------------

MOVING PARTS can injure.

Keep guards in place.

Keep away from moving parts.

Only qualified personnel should install, use or service this equipment.

C. FLEXIBLE HOSE

D. GEAR CLAMP

E. AIR FILTER

Above 60°F / 15.5°C (Summer Season Configuration)

1.With the engine OFF, remove the negative cable from the battery.

2.Remove the FLEXIBLE HOSE from the HEAT COLLECTOR SHIELD outlet tube.

3.The FLEXIBLE HOSE is to be positioned per fig- ure 2.

IMPORTANT: 1/2” clearance between the FLEXI- BLE HOSE and the fuel tank edge is required. Also 2” clearance between FLEXIBLE HOSE and roof.

4.Reconnect negative battery cable.

------------------------------------------------------------------------

The engine MUST BE COLD before seasonal change over of the carburetor deicing kit.

When the AVERAGE AIR INTAKE TEMPERATURE (Average Ambient) is:

Below 60°F / 15.5°C (Winter Season Configuration)

1.With the engine OFF, remove the negative cable from the battery.

2.Push the FLEXIBLE HOSE fully onto the HEAT COLLECTOR SHIELD outlet tube, see Figure 1.

3.Reconnect negative battery cable.

FIGURE 1

E

D

C

AB

FIGURE 2

AB C

A. FLEXIBLE HOSE

B. HEAT COLLECTOR SHIELD

C. AIR FILTER

NOTE: On welders received directly from the factory, the “Deicing” kit is configured for “summer Seasons”

A. FUEL TANK

B. HEAT COLLECTOR SHIELD

CLASSIC I

Image 15
Contents Classic Safety Depends on YouCalifornia Proposition 65 Warnings SafetyElectric Shock can kill Iii Welding Sparks can cause fire or explosionSûreté Pour Soudage a L’Arc Précautions DE SûretéPlease Examine Carton and Equipment For Damage Immediately Thank YouMaster Table of Contents for ALL Sections Engine InstallationTechnical Specifications Classic MachineDesign Summary General DescriptionLocation / Ventilation PRE-OPERATION InstallationSafety Precautions Machine GroundingTrailers See optional features Lift Bail Polarity Control and Cable SizesFalling Equipment can cause To prevent Explosion when Battery ChargingOil Fuel Cooling SystemOperation Engine OperationWelder Operation Carburetor Deicing Kit Auxiliary PowerControl of Welding Current Idler OperationBelow 60F / 15.5C Winter Season Configuration Above 60F / 15.5C Summer Season ConfigurationAccessories Maintenance MaintenanceNameplates Idler MaintenanceBearings Commutator and BrushesHOW to USE Troubleshooting Guide 1TROUBLESHOOTINGE-1Problems TroubleshootingJULY97 Classic Improper valve clearance Possible Areas Recommended Symptoms Electronic Idler Troubleshooting Guide Classic Wiring Diagram DiagramsDimension Print $700.00 How To Read Shop DrawingsNew Lessons in Arc Welding Need Welding Training?Precaucion Warnung