Lincoln Electric IM886 manual Figure C.2 Welding Arms

Page 18

C-2

ACCESSORIES

C-2

 

 

 

8.Extend the hose and cable(s) out through the right front 2" tube about 32" and then feed them through one of the 15" long black 2" hoses. Feed the cables and black tube through the right tube of the back of the mini console. The back cover should be facing forward with the two pipes extending to the rear and the two mounting brackets facing up towards the universal feeder support.

9.Connect the 3/8" braided air hose and gear clamp to the hose connector mounted on the Mini Console Body.

10.Feed the electrical cable through the romex con- nector and attach the 120 VAC receptacle. Install the receptacle and cover plate.

11.Install a quick disconnect air fitting (not included) to the front of the short anchor coupler.

12.Verify all connections.

13.Slip the 5" piece of 2" spiral hose over the rear of the vacuum inlet.

14.Install the Mini Console Rear Cover, making sure the 5" long, 2" spiral hose slips over the left pipe of the rear cover and compresses as the panel is screwed into place. Install the two top outside #8 x 1/2" self drilling screws first and then pivot the rear cover to allow the three bottom screws to be installed. Tighten all five screws. Drill two 1/8" diameter holes through the prepunched bottom outside holes in the mini console into the back cover. Install and tighten two #8 - 1/2" long screws.

15.Secure the two brackets of the back cover to the four mounting holes in the universal feeder sup- port using 1/4"-20 x 1" carriage bolts and lock washers.

16.Slide the two 15" long x 2" diameter black hoses over the rear of the back cover pipes.

17.Install the universal feeder support and mini con- sole assembly to the arm making sure both 2" diameter hoses fit over the outer structural tubes of the arm.

18.Install a 20" long x 1-1/2" diameter hose over the electrical cable and air hose at the rear of the arm and slide it halfway into the tube to protect the cable and hose from wear. Secure the hose with an adhesive (not included.)

19.Make final electrical connections by installing a plug to the end of the electrical cable. Plug into an approved GFI outlet.

20.Install the appropriate air fitting to the end of the 3/8" braided air hose and connect to an air supply.

21.After installing K1779-11 Mini Console, verify proper connections to the electrical outlet (neutral, hot and ground circuits) by using a plug-in circuit tester.

FIGURE C.2

WELDING ARMS

Image 18
Contents Safety Depends on You Lincoln Welding ArmsSafety California Proposition 65 WarningsElectric Shock can kill Welding Sparks can cause fire or explosion IiiPrécautions DE Sûreté Thank You Table of Contents Recommended Processes and Equipment Product DescriptionProduct Summary General Physical DescriptionCommon Equipment Packages Series Stanchion MountSpecifications Design FeaturesProduct Specific Installation Instructions InstallationNON-STANDARD Safety Information Location15.2 Installation Weld Cable Sizes To change the arm triangle position Adjusting for Wire Feeder WeightAdjusting the Welding ARM Travel To change the tension clevis positionSafety Precautions Shielding GAS Connection OperationMini Console Assembly Instructions AccessoriesOptions and Accessories K1779-11 Mini ConsoleFigure C.2 Welding Arms K1779-9Universal Wire Feeder Bracket K1779-14 x 4 x 1 Lift Truck PlatformK1779-13Single Electrode Liner Kit K1779-8Wire Spindle Mounting Bracket K1779-7Dual Gas Cylinder Holder KitMaintenance Routine MaintenanceDimension Print Welding Arms Welding Arms Welding Arms Precaucion Warnung