Lincoln Electric IM886 K1779-14 x 4 x 1 Lift Truck Platform, K1779-13Single Electrode Liner Kit

C-3 ACCESSORIES C-3

K1779-14' x 4' x 1" Lift Truck Platform.

(See Figure C.3)

Platform for use with the 6000 series stanchion arm. Install and secure at least 300 lb (136kg) of weight onto the platform. A welding power source may be sufficient for this purpose. Verify the weight of the power source.

	FIGURE C.3
	48”
48”			6”
Counterweight			15.5”
	location
			6”	7”
8”	16”	8”

3.Secure the assembled PVC tubing to the "A" and "B" brackets using the gear clamps.

4.If a Spindle Mounting Kit is used, mount the "C" bracket to the spindle Align the bracket as neces- sary for proper wire alignment.

5.Slide the liner conduit through the PVC tubing. Secure the liner conduit to the "C" bracket with the split nylon sleeve and gear clamp.

FIGURE C.4

3”

K1779-13Single Electrode Liner Kit

(See Figure C.4)

Includes liner, brackets and hardware for mounting to a 6000 series arm.

Note: If using a wire feeder with dual drives, two liner kits are required.

1.Mount the two "A" brackets and one "B" bracket to the arm. Mount the brackets on either the right or left side of the arm to match the wire drive location on the wire feeder. The "A" brackets mount at the front and middle of the arm. The "B" bracket mounts towards the rear.

2.Assemble the three pieces of PVC tubing by firmly inserting the plain ends into the expanded ends.

K1779-9Universal Wire Feeder Bracket

(See Figure C.5)

Bracket for holding the wire feeder at the end of the arm. Includes bracket and mounting hardware.

FIGURE C.5

WELDING ARMS