Lincoln Electric IM646-A manual K466-7, and K466-10 Installation Hobart Series, Figure B.1

A-4 INSTALLATION A-4

K466-5 INSTALLATION (For L-Tec Feeders equipped with an L-Tec feeder connector assembly, MIG 35, MIG 31A, 225...)

a. Remove brass cable connector (see Figure B.1) from the kit and screw it onto the feeder end of the gun cable. Tighten the connection with the wrench provided.

b. Check that the molded gas plug fitting is sealing the gas fitting hole in the side of the feeder end handle.

c. The gun control cable provided is not used.

K466-7, and K466-10 Installation (Hobart Series

2000 Feeders, and Lincoln -10 Series Feeders)

a. Remove brass cable connector (see Figure B.1) from the connector kit and screw it onto the feeder end of the gun cable. Tighten the connection with the wrench provided.

b. Check that the molded gas plug fitting is sealing the gas fitting hole in the side of the feeder end handle.

c. The gun control cable provided is not used.

Figure B.1

MAGNUM® 400 DUAL PROCEDURE GUNS