Lincoln Electric IM646-A manual Figure E.8

D-6 MAINTENANCE D-6

For K1722:

The control cable leads should be connected to the same color leads on the gun cable. Insulate each of the solder connections with either heat shrink tubing or electrical tape. Anchor leads as shown in Figure

E.8. Position the plastic strain relief such that the tapered end is 4.68 (119 mm) from the incoming con- nector (See Figure E.6). Lock into place with steel housing. Plastic strain relief may overhang cable jacket a maximum of .43" (11 mm).

Figure E.8

h)Position cable boot and cable handle on cable. Move the connector cover into position while pulling control cables to take up the slack. Install tailpiece and fasten to cable handle with cable han- dle nut. (Refer to Figure E.6).

I)Replace the molded gas plug (or barbed fitting) and feeder end connector. Install and trim liner per previous instructions.

MAGNUM® 400 DUAL PROCEDURE GUNS