Friedrich SQ08, SQ10, SQ06, SQ05 operation manual Standard Window Installation, Falling Object Hazard

Standard Window Installation

WARNING

Falling Object Hazard

Not following Installation Instructions for mounting your air conditioner can result in property damage, injury, or death.

STEP 1. After removing the unit from shipping carton, (See Figure 14).

STEP 2. Attach curtain assemblies to cabinet as shown in Figure 13. Use eight (8) No. 8 x 3/8" slotted hex head screws (item #1, page 22).

Figure 13

SHELL SUPPORT

STEP 3. Center cabinet in window with sill channel positioned against window stool as shown in Figure 15, Section A-A.

STEP 4. Pull window sash down behind Shell Support Channel on top of cabinet; this helps hold cabinet in place. Install No. 8 x " hex head screw (item #3, page 22) in sill channel at bottom of window opening as shown in Figure 15.

STEP 5. Extend the sliding curtains on each side so the frames fit into the window channels. While holding the curtain frames in place, mark four (4) hole locations (hole locations are in the upper corners on left and right curtain assembly), two (2) in the window jamb and two (2) in the window sash. Slip the curtains back from marked locations and drill four (4) 7/64" diameter pilot holes. Again, extend the sliding curtains on each side and then install two (2) No. 8 x ½" Phillips head screws (item #2, page 22) and two (2) No. 8 x 1 ¼" Phillips head screws (item #4) through the curtain frames as shown in Figure 15.

CAUTION

Excessive Weight Hazard

CURTAIN ASSEMBLY RETAINING

BRACKET

CHANNEL

Use two or more people when installing your air conditioner.

Failure to do so can result in back or other injury.

CURTAIN
ASSEMBLY
(LEFT)
SCREW #8 x 3/8” SLOTTED HEX HEAD
(ILLUSTRATION ON PAGE 22, ITEM #1)
8 REQUIRED (4 EACH SIDE). INSTALL	CURTAIN
FROM INSIDE SLEEVE TO CURTAIN
ASSEMBLY RETAINING BRACKET.	ASSEMBLY
	(RIGHT)
	FRR085

CAUTION

Cut/Sever

Although great care has been taken to minimize sharp edges in the construction of your unit, use gloves or other hand protection when handling unit

Failure to do so can result in minor to moderate personal injury.

Figure 14

TO PULL UNIT FROM SLEEVE, USE THE SIDE HANDLES LOCATED ON EITHER SIDE OF THE UNIT DECORATIVE FRONT. OBTAIN ASSISTANCE OR HELP AS NECESSARY TO HOLD SLEEVE WHILE PULLING UNIT FROM SLEEVE. MAKE SURE AIR CONDITIONER IS ON FIRM SUPPORT BEFORE REMOVING UNIT FROM SLEEVE.

WHEN CARRYING OR HANDLING UNIT, OBTAIN ASSISTANCE OR HELP AS NECESSARY TO SUPPORT UNIT FROM BOTTOM (BASEPAN), MAINTAINING CLEARANCE FROM ALL OBSTACLES.

SIDE HANDLE

FRR086

23