8.Make further adjustments as needed.
9.Tighten the hex nut to secure the setting.
Abrasive Disc Replacement
1.Unplug the sander from the power source.
2.Remove the dust cover and the disc table. To remove the disc table, remove the handles then tilt the disc table upward while pulling it away from the disc.
3.Peel off the old abrasive disc.
4.Thoroughly clean the aluminum disc surface using naptha or a similar
5.Pull the protective backing
6.Carefully position the new abrasive disc so it is centered accurately on the aluminum disc.
7.When accurately centered, remove the rest of the protective backing and press the abrasive disc firmly against the aluminum disc so complete adhesive contact is made.
8.
9.Reconnect sander to power source.
Aluminum Disc Removal
The aluminum disc can be easily removed if needed; for example, to facilitate cleaning the aluminum disc when replacing abrasive discs.
1.Unplug sander from the power source.
2.Remove the disc table and the dust chute.
3.Rotate the disc until the set screw is accessible through the opening behind the disc guard. See Figure 15. You may need to loosen the socket head cap screws (see Figure 4) on the guard and shift it forward in order to clear the set screw.
4.Loosen the set screw with a 3mm hex wrench, and pull the aluminum disc off the motor shaft.
5. When | Figure 15 |
| |
sure the key is properly seated in the |
|
keyway on the motor shaft. Tighten the set |
|
screw firmly when the disc has been |
|
mounted. |
|
15