Wilton 41002 manual Unpacking, Contents of the Shipping Container

Page 8

Unpacking

Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the sander is assembled and running properly.

Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

Contents of the Shipping Container

1Belt and Disc Sander

1Belt Table

1Disc Table with trunnions

1Miter Gauge

1Dust Chute

6Phillips Pan Hd. Machine Screws, 3/16x3/8”

3Handles

3Flat Washers, 3/8”

1Tension Handle

1Hex Nut, 1/4”

3Hex Wrenches, 3, 4 and 6mm

1Owner's Manual

1Warranty Card

Read and understand the entire contents of this manual before attempting set-up or operation! Failure to comply may cause serious injury.

8

Image 8
Contents Belt and Disc Sander Part No. M-41002Warranty and Service More Information WMH Tool Group WarrantyTable of Contents Page Page Introduction Specifications Features and Terminology Contents of the Shipping Container UnpackingAssembly Installing Belt TableInstalling Dust Chute Tools needed for assemblyInstalling Tension Handle Installing Disc TableInstalling Miter Gauge Grounding Instructions Volt OperationAdjustments Extension CordsTilting the Belt Table Tilting the Disc TableUse of the Miter Gauge Belt PlatenAbrasive Belt Replacement Tracking the Abrasive BeltAbrasive Disc Replacement Aluminum Disc RemovalOperation Starting and Stopping the SanderBelt and Disc Movement Typical OperationsPage Maintenance Replacement PartsProbable Cause Remedy TroubleshootingTrouble 2x42x8 Belt and Disc Sander Parts List for 2x42x8 Belt and Disc Sander Index No. Part No Description Size QtyTS-1505021 Socket Head Cap Screw Page WMH Tool Group