Wilton 41002 Assembly, Installing Belt Table, Installing Dust Chute, Tools needed for assembly

Page 9

Assembly

Tools needed for assembly:

10mm open-end wrench

Cross-point (Phillips) screwdriver

Combination square, or similar angle measuring device.

Sander must be unplugged from power source during assembly.

Remove the protective coating from the surfaces of the sander and from any loose parts. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover the table surfaces with a good quality paste wax.

Leave enough space around the sander for long workpieces and for general maintenance.

If needed, the sander can be bolted to a table or workbench using the holes in the base. If the sander has a tendency to walk or slide during operation, it must be bolted to a supporting surface.

Installing Belt Table

1.Unscrew the stud. See Figure 1.

2.Position the bracket of the belt table over the holes in the casting as shown, and re-install the stud into its hole.

3.Place a flat washer onto a handle, and insert the handle through the table bracket and into the hole. Screw the handle all the way into the hole.

NOTE: The handle is spring loaded; screw the handle in by rotating clockwise, then pull outward on the handle. Rotate the handle back to position, then release it, making sure it seats itself upon the pin. Continue the process until the handle is tightened in the hole.

Installing Dust Chute

The sander has two 1-1/2” diameter dust chutes. The dust chute for the belt is located on the belt cover. The dust chute for the disc should be installed as shown in Figure 2, using the six (6) pan head machine screws that are provided.

The dust chutes can be connected to a vacuum system to collect dust particles.

9

Figure 1

Figure 2

Image 9
Contents Part No. M-41002 Belt and Disc SanderMore Information WMH Tool Group Warranty Warranty and ServiceTable of Contents Page Page Introduction Specifications Features and Terminology Unpacking Contents of the Shipping ContainerInstalling Belt Table AssemblyInstalling Dust Chute Tools needed for assemblyInstalling Disc Table Installing Miter GaugeInstalling Tension Handle Volt Operation Grounding InstructionsExtension Cords AdjustmentsTilting the Belt Table Tilting the Disc TableBelt Platen Use of the Miter GaugeTracking the Abrasive Belt Abrasive Belt ReplacementAluminum Disc Removal Abrasive Disc ReplacementStarting and Stopping the Sander OperationBelt and Disc Movement Typical OperationsPage Replacement Parts MaintenanceTroubleshooting TroubleProbable Cause Remedy 2x42x8 Belt and Disc Sander Index No. Part No Description Size Qty Parts List for 2x42x8 Belt and Disc SanderTS-1505021 Socket Head Cap Screw Page WMH Tool Group